TMS-4 Software Install

More documents

Recommendations

Info

4 Click on Hardware tab and click Device Manager… to go to Device Manager 12
5 Double Click “Ports (COM & LPT)” and check there is “ECP Printer Port (LPT1)” Note -When the port is NOT setup as ECP Printer Port, please refer to the operating manual of your PC or ask the dealer for help. -When LPT1 (or the port that is connected with TMS-4) is not setup as ECP, TMS-4 does not work normally. -The Paralell port on your PC may be occupied by normal printer. Though the printer is connected through TMS-4 output port, it is not available to use TMS-4 and printer at the same time. -Universal Serial Bus (USB) port is recommended to use both TMS-4 and Printer with the same PC 13
Page 1 and 2: TMS-4 Software Install
Page 3 and 4: Step1:Setup Drivers TMS-4 driver sh
Page 5 and 6: 4 Click on Hardware tab and click D
Page 7 and 8: 6 Double click “ECP Printer Port
Page 9 and 10: 7 Click Click Selcet “CD-ROM driv
Page 11 and 12: Click 9 Click
Page 13: WindowsXP 1 Start WindowsXP (Log in
Page 17 and 18: ① Select ② Click 15 ② Click
Page 19 and 20: Go to “CD-ROM Drive” - ”Drive
Page 21 and 22: 19 Click
Page 23 and 24: Step2:TMS-4 Software Install In thi
Page 25: Step3:VKS Calibration Table Install

TMS-4 Software Install

Create successful ePaper yourself

Delete template?

Save as template?