instructions for use creation press-ceramics zirconium oxide

More documents

Recommendations

Info

CUT BACK TECHNIQUE – FINISHING 10 Cut off the sprues carefully using a suitable cut-off-disc. Work with low pressure and low r.p.m. (revolutions per minute). After separating, the work is carefully fitted onto the die. Caution in the area zirconium oxide/press ceramic: Intense heat can cause breaks! The fully anatomically modelled restoration should be reduced or prepare the already reduced restoration for veneering.
CUT BACK TECHNIQUE – BUILD-UP 3a 1 2 11 3b 4 5 Use Creation ZI or ZI-F for the build-up. Additional staining with Creation AV.ZI.TI. Make Up Instant can be carried out and fired before building-up. Build up the incisal sections and fire according to the firing chart. Dentine porcelain can be used to build up sections with insufficient dentine. A further add-on firing is carried out if required. Small accentuating highlights can still be added using stains. Firing is carried out on pins, but be careful that the shoulder doesn’t touch the firing pin. Restoration can be glazed or polished.
Page 1 and 2: CREATION WILLI GELLER INTERNATIONAL
Page 3 and 4: 3 INTRODUCTION It is possible with
Page 5 and 6: FRAME SHADE 5 It’s recommended to
Page 7 and 8: INVESTING 7 Push the silicon ring o
Page 9: DEVESTING 9 Mark the length of the
Page 13 and 14: STAINING POSTERIOR 1 2 3 4 5 6 13 S
Page 15 and 16: COLOUR CHART DENTINE PELLETS 2g Vit
Page 17 and 18: C U T B A C K E A S Y - C O M B I N
Page 19 and 20: PHYSICAL PROPERTIES Properties Meas

instructions for use creation press-ceramics zirconium oxide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?