Operating and Safety Instructions - Sauer

Handling
5.7.4 Uncock the firing pin
WARNING!
Careless actions may cause uncontrolled
discharge of shot
May lead to death or severe injuries
• Only uncock the firing pin with the rifle
unloaded and the barrel chamber empty.
Procedure:
1. Unload the rifle and check that there is no
round in the barrel chamber (see section 5.6).
2. Pull the trigger tongue and slowly close the
bolt with the trigger tongue held pulled.
Note:
• The cocking indication must not be visible
(see Fig. 8).
5.8 Magazine
5.8.1 Removing the magazine
Procedure:
1. Hold magazine 600 by hand.
2. If fitted: Push magazine safety towards the
magazine (see section 3.8.2).
CAUTION!
Magazine may fall out
Magazine may be damaged
• When removing the magazine always keep
your hand exactly underneath the magazine.
3. Press the stud 207 with the index finger of the
same hand.
4. Remove magazine.
5. Empty magazine.
Fig. 10
5.8.2 Inserting the magazine
Procedure:
1. Insert the magazine into the magazine shaft
and push upwards until the magazine engages
audibly. Do not jam the magazine.
2. If fitted: Push magazine safety towards the
barrel (see section 3.8.2).
5.8.3 Loading the magazine
Procedure:
1. Push the rear feeder down.
2. Push the round from the front under the
magazine lip.
Fig. 11
207
19 GB
10.07