Operating and Safety Instructions - Sauer

Assembly
9.2 Fitting the main stock
Corresponding figure, see Fig. 17.
Procedure:
1. Slide the main stock onto the rifle.
2. Hand-tighten the main stock screw clockwise
with the long end of the special spanner
supplied (approx. 5 turns).
3. Fit the sling attachment (see section 9.4).
9.3 Fitting the front stock
Corresponding figure, see Fig. 21.
Procedure:
1. Slide the front stock 502 onto the rifle and
press the sides of the front stock into the sides
of the receiver.
2. Hand-tighten the front stock screw clockwise
with the long end of the special spanner
supplied.
3. Fit the sling attachment (see section 9.4).
Fig. 21
502
9.4 Fitting the sling attachment
Corresponding figure, see Fig. 16.
Procedure:
1. Insert the bolt of the rear sling attachment into
the sling attachment bushing 407.
2. Press in the spring bolt.
3. Gently turn the sling attachment until the bolt
safety lock engages.
4. Insert the bolt of the front sling attachment into
the front sling attachment bushing 503.
Note:
• The sling attachment must be aligned
exactly 90° to the orientation of the barrel.
• The bolts must protrude clearly above the
edge of the sling attachment body.
10.07 GB
30