OWNER'S MANUAL - Health Mate Far Infrared Sauna

Recommendations

Info

[P.10] (14) POWER SUPPLY CONNECTIONS (15) DOORKNOB INSTALLATION Assembly Instructions Cont’d Make power supply cable connections on the front panel. 1. Located on the lower right hand corner (when looking at it from inside of the sauna facing the door) of the front panel is a wooden box with a cover. Lift up the cover to reveal a power supply. 2. Plug in the female end of the main power cord into the male inlet (labeled “INLET”) on the power supply. 3. Plug in the male power cable from the front of the bottom panel into the female inlet (labeled “REAR HEATER”) on the power supply. 4. Make sure all connections are secure and close the wooden cover. FEMALE PLUG (MAIN POWER CORD) MALE POWER PLUG (BOTTOM PANEL) PLEASE DO NOT REMOVE LABEL. DO NOT CONNECT MALE AND FEMALE PLUGS TOGETHER. EACH PLUG MUST BE CONNECTED ONLY TO ITS CORRESPONDING INLET ON THE POWER SUPPLY. Locate the doorknob, screws, and wooden pegs which can be found in the accessory box. 1. Align the doorknob against 2 holes on the outside of the door. 2. Insert the screws into the holes on the inside of the door and screw into the 2 holes in the doorknob until they are snugly fit. 3. Insert the wooden pegs into the holes on the inside of the door. HOLE DOORKNOB HOLE SCREWS WOODEN PEGS
[P.11] <strong>Health</strong> <strong>Mate</strong> corner type unit comes packaged in 2. 1. Front Panel 2. Top Panel 3. Right Back Panel 4. Accessory Set Benches & Bench Heater Panels Corner Type Packaging and Individual Panel Information Contents of A-Box Contents of B-Box 1. Bottom (Floor) Panel 2. Left Side Panel 3. Right Side Panel 4. Bench Heater Panel 5. Benches 6. Left Back Panel *WARNING!!! The receptacle provided by the manufacturer must be installed by a qualified electrician only. PANEL Front Panel Bench & Bench Heater Top Panel Side Panels DESC. • Door with Full Glass Window • Dual Digital Controls: Inside & Outside • Outside: Radio/CD Player with detachable faceplate • Inside: Heaters, Serial Number Label, and Warning Label • Bench: the smooth and finished end should face forward and up when installing • Bench Heater: make sure that the “TOP” sticker is facing up and heater facing forward when installing • Ventilator: adjustable from inside • Outside Front End: Antenna & Wooden Sliding Door • Inside Back End: A pair of Speakers & Ventilator(s) • Interior Light Front Panel Top & Bottom Panels Left Back Panel Right Back Panel Side Panels Backrest • Left & Right Side Panels • Inside: Horizontal Bench Guides and Vertical Bench Heater Guides • When positioning the side panels during assembly, make sure that the guides are facing inward and each other. PANEL Bottom Panel Back Panels Backrest Accessory Box DESC. • When positioning the bottom panel, make sure that the side with “FRONT” sticker faces forward in the direction of the front panel. TOP BOTTOM X2 • Inside: Heaters, Power Inlets and Wooden Web Back • It can be positioned against either side panels or back panel for added comfort. See Page (4) LEFT RIGHT
Page 1 and 2: [P.1] OWNER’S MANUAL [ Health Mat
Page 3 and 4: [P.3] * For instructions for corner
Page 5 and 6: [P.5] Assembly of the sauna require
Page 7 and 8: [P.7] (6) ROUTING OF MAIN POWER COR
Page 9: [P.9] (11) PLACING TOP PANEL (12) I
Page 13 and 14: [P.13] Corner Type Assembly Instruc
Page 15 and 16: [P.15] Corner Type Assembly Instruc
Page 17 and 18: [P.17] Enjoying Your Health Mate Sa
Page 19 and 20: [P.19] SESSION SETTING MODE CONTINU
Page 21 and 22: [P.21] Safety Instructions 1. Read
Page 23 and 24: [P.23] Covers to fit all models: Ou
Page 25 and 26: [P.25] STARLIGHT OPERATION Optional
Page 27 and 28: [P.27] Troubleshooting Guide Proble
Page 29 and 30: [P.29]

OWNER'S MANUAL - Health Mate Far Infrared Sauna

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?