OWNER'S MANUAL - Health Mate Far Infrared Sauna
OWNER'S MANUAL - Health Mate Far Infrared Sauna
OWNER'S MANUAL - Health Mate Far Infrared Sauna
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
[P.7]<br />
(6) ROUTING OF MAIN POWER CORD<br />
Run the main power cord, found in the accessory box, through the hole on the front left corner of the<br />
bottom panel.<br />
Make sure that the male plug on the main power cable, which will be plugged into the wall outlet, is<br />
routed through the hole to the underside of the bottom panel so that it can be pulled out from underneath<br />
the bottom panel.<br />
Do not pull the main power cord all the way through the hole on the bottom panel. Make sure to leave<br />
about 12 inches of the female end of main power cable on the bottom panel (inside the sauna).<br />
(7) INSTALLING BENCH HEATER PANEL<br />
Assembly Instructions Cont’d<br />
MALE PLUG OF<br />
MAIN POWER CABLE<br />
MAIN<br />
POWER CABLE<br />
FEMALE END<br />
OF MAIN<br />
POWER CABLE<br />
Slide down the bench heater panel by lining up its sides with the vertical guides on each side panel.<br />
1. The bench heater panel must be positioned so that the “TOP” sticker is facing up and the red heater<br />
grill is facing outward (toward the front of the sauna).<br />
2. Be careful not to scratch the side panels when positioning the heater panel.<br />
3. Make sure that the bench heater cable is not wedged under the heater panel.<br />
4. Push the bench heater panel all the way down until it is touching the bottom panel and securely in<br />
place.<br />
XSE-4 MODEL ONLY: Before installing the bench heater panel, skip to Step (10) to install the front panel<br />
first because vertical bench heater guides are located on the back and front panels for XSE-4 models. Then<br />
skip to Step (15) and make connections on the power supply, which is located on the lower left hand corner<br />
of the front panel, behind the bench heater panel. There are 2 bench heater panels for XSE-4 models. Follow<br />
the same precautions in Step (7) when installing the bench heater panel.<br />
“TOP” STICKER MUST BE<br />
FACING UP AND RED<br />
HEATER GRILL MUST BE<br />
FACING OUTWARD<br />
VERTICAL BENCH HEATER<br />
PANEL GUIDES ARE FOUND<br />
ON THE SIDE PANELS.<br />
FOR XSE-4, THEY ARE ON<br />
THE FRONT & BACK PANELS.