OWNER'S MANUAL - Health Mate Far Infrared Sauna
OWNER'S MANUAL - Health Mate Far Infrared Sauna
OWNER'S MANUAL - Health Mate Far Infrared Sauna
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
[P.13]<br />
Corner Type Assembly Instructions Cont’d<br />
(4) INSTALLING BENCH HEATER PANEL<br />
When installing bench heater panel, be careful not to scratch the side panels when positioning the heater<br />
panel. Make sure that the bench heater cable is not wedged under the heater panel. Push the bench<br />
heater panel all the way down until it is touching the bottom panel and securely in place. If you need further<br />
information, please refer to Assembly Instructions #7 (page 7) on Owner’s Manual.<br />
(5) PLUGING BENCH HEATER/BACK PANEL CABLES<br />
Connect the bench heater and the bottom cable to the inlets located on the back panels. Follow the<br />
instructions below. Extra Cable in picture C can be found in the accessory box. Make sure that the<br />
connection is secure and plugged in all the way.<br />
A<br />
(6) ROUTING OF MAIN POWER CORD<br />
Run the main power cord, found in the accessory box, through the hole on the front left corner of the<br />
bottom panel.<br />
Make sure that the male plug on the main power cable, which will be plugged into the wall outlet, is<br />
routed through the hole to the underside of the bottom panel so that it can be pulled out from underneath<br />
the bottom panel.<br />
Do not pull the main power cord all the way through the hole on the bottom panel. Make sure to leave<br />
about 12 inches of the female end of main power cable on the bottom panel (inside the sauna).<br />
MALE PLUG OF<br />
MAIN POWER CABLE<br />
2<br />
1<br />
B C D<br />
Extra Cable<br />
MAIN<br />
POWER CABLE<br />
FEMALE END<br />
OF MAIN<br />
POWER CABLE