EM920 IEC 61850 - Satec

More documents

Recommendations

Info

32 in functional constraint CF are defined in the ICD file. They can be changed to provide reasonable conditions for generating reportable events. Textual descriptions The default d (textual description of the data) attribute values in functional constraint DC are defined in the device. They can be changed for descriptions of measured/metered and status data.
6 Configuring IEC 61850 You can use the PAS software provided with your meter to configure the IED name and default deadbands for measured analog values. See the EM920 Operation Manual for more information on installation and operating PAS on your computer. 6.1 Licensing IEC 61850 A valid license key must be provided in the EM920 for IEC 61850 communications. The device is normally shipped with a temporary license, which is valid for a 30-day operation and then can be extended for an additional month. A permanent license can be obtained from your local distributor for an additional fee. A device serial number must be provided in the license request. The device may also be shipped with the permanent license in the event of a pre-paid fee. To program a license key in you device: 1. Select Administration->Update License from the Monitor menu. 2. Type in the license code. 3. Click on Send. 6.2 Configuring IED Properties This setup allows you to configure the IED name of your device that will accompany logical device names and change the default connection idling timeout used to close inactive connections. To configure the IED: 1. Select IEC 61850 Setup from the Meter Setup menu, and then click on the IEC 61850 IED Properties tab. 2. Configure the IED name and change the connection idle timeout if required. Other IED attributes are not changeable via this setup and are indicated for information only. 3. Send your setup to the device and save it to the device database. 33
Page 1 and 2: Power Quality and Revenue Meter EM9
Page 3 and 4: Table of Contents 1 General........
Page 5 and 6: 1 General The EM920 is provided wit
Page 7 and 8: Services Client/ Subscriber Server/
Page 9 and 10: Services AA: TP/MC Client/ Subscrib
Page 11 and 12: Pulse configuration Attribute Name
Page 13 and 14: Complex measured value (CMV) Attrib
Page 15 and 16: Controllable analog set point infor
Page 17 and 18: Mod INC Mode M Beh INS Behavior M H
Page 19 and 20: Attribute name Attribute type Expla
Page 21 and 22: A WYE Phase and neutral currents O
Page 23 and 24: Attribute name Attribute type groun
Page 25 and 26: MMS service supported CBB (server)
Page 27 and 28: 5 PIXIT - Protocol Implementation E
Page 29 and 30: Reporting model Data Set name Membe
Page 31: Item Value/Comments Separator for f
Page 35: 3. Send your setup to the device. T

EM920 IEC 61850 - Satec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?