ML505/506 Four GTPs IBERT Quickstart - Xilinx

More documents

Recommendations

Info

Setting Up the Hardware • Connect SATA “Crossover” Cable (included with ML505 kit) – Connect J40 to J41 Note: Presentation applies to the ML505 and ML506
Setting Up the Hardware • Connect SATA Frequency jumper J56 – Provides 150 MHz clock source for MGT114 (X0Y2) – See the ML505 User’s Guide for more details Note: Presentation applies to the ML505 and ML506
Page 1 and 2: ML505/506 Four GTPs IBERT QuickStar
Page 3 and 4: Xilinx ML505 Board Note: ML505 show
Page 5 and 6: ISE Software Requirement • Xilinx
Page 7: Setting Up the Hardware • Connect
Page 11 and 12: Setting Up the Hardware • SMA Cab
Page 13 and 14: Setting Up the Hardware • Connect
Page 15 and 16: Setting Up the Hardware • On the
Page 17 and 18: Extracting the Design • Unzip the
Page 19 and 20: ChipScope Setup • Select Device
Page 21 and 22: Running IBERT • Click Yes on this
Page 23 and 24: IBERT ChipScope TX Settings • Dif
Page 25 and 26: IBERT ChipScope BERT Settings • T
Page 27 and 28: • Virtex-5 - Silicon Devices Docu
Page 29 and 30: • Virtex-5 RocketIO - RocketIO GT
Page 31 and 32: • Additional Design Resources - C
Page 33 and 34: Documentation • Ethernet - Virtex
Page 35 and 36: • ML505/506/507 - ML505 Overview

ML505/506 Four GTPs IBERT Quickstart - Xilinx

Create successful ePaper yourself

Delete template?

Save as template?