Installation Guide V8.5.6.0 - ApexCCTV

More documents

Recommendations

Info

Connecting One GV-4008 Card 24 • Connect the video and audio cables to the GV-4008 Card. • Using the supplied SATA Power Converter Cable, connect the GV-4008 Card to power supply. The Power LED in the top right corner should be lit in green and the 4 status LEDs (D3, D9, D14, D18) in the left corner should be lit in green to indicate the normal functionality. Audio 1~8 Video 1~8 Status LEDs Figure 1-16 GV-4008 Card Power LED SATA Power Converter Cable Note: 1. The GV-4008 Card only works when the supplied USB Dongle is inserted to PC. Reset LED Hardware Watchdog 2. The GV-4008 Card cannot work with microphones which acquire power from the PC. Use microphones which have external power supply.
Connecting Two GV-4008 Cards 1 Video Capture Cards You can install two GV-4008 Cards for a total of 16 channels. Master Card is the card with 1- 8 channels and Slave Card is that with 9-16 channels. Normally, the card attached to the lower PCI slot number will act as Master, and the card attached to the higher PCI slot number will act as Slave. • Hardware Watchdog Connection: Connect the supplied Hardware Watchdog Jump Wire to the Master Card only (Figure 1-18). • Accessory Card Connections: To work together with GV-4008 Cards, GV-NET/IO Card V3.1 must be set in the I/O Box Mode and connected to the PC through USB or DB9. Audio 1~8 Video 1~8 Audio 9-16 Video 9-16 GV-4008 Card (Master) GV-4008 Card (Slave) Figure 1-17 Hardware Watchdog SATA Power Converter Cable SATA Power Converter Cable 25
Page 1 and 2: Installation Guide V8.5.6.0 Before
Page 3 and 4: Contents Important Notice..........
Page 5 and 6: Important Notice GPU Decoding Speci
Page 7 and 8: Frame rate limit in a single hard d
Page 9 and 10: 6. GV-600A, GV-650A and GV-800A:
Page 11 and 12: 1.1 GV-SDI-204 1 Video Capture Card
Page 13 and 14: Connecting Hardware Watchdog 1 Vide
Page 15 and 16: Adjusting the Video Settings in the
Page 17 and 18: Specifications GV-SDI-204 Interface
Page 19 and 20: Connecting One GV-5016 Card • Con
Page 23 and 24: Adjusting the Video Settings in the
Page 25 and 26: 1 Video Capture Cards 11. To adjust
Page 27: 1.3 GV-4008 1 Video Capture Cards T
Page 31 and 32: Installing Drivers 1 Video Capture
Page 33 and 34: 1 Video Capture Cards 2. Select the
Page 35 and 36: Specifications GV-4008 GV-4008 x 2
Page 37 and 38: Connecting One GV-4008A Card • Co
Page 41 and 42: Specifications GV-4008A GV-4008A x
Page 43 and 44: Connecting One GV-3008 Card • Con
Page 45 and 46: Video/Audio 1~4 Video/Audio 5~8 Vid
Page 49 and 50: 1.6 GV-1120A, 1240A, 1480A 1 Video
Page 51 and 52: Connecting One GV-Combo A Card (D-T
Page 53 and 54: Connecting GV-NET/IO Card to GV-Com
Page 57 and 58: Specifications Interface Type PCI-E
Page 59 and 60: 1.7 GV-1120B, GV-1240B, GV-1480B 1
Page 61 and 62: Connecting Two GV-Combo B Cards 1 V
Page 65 and 66: Interface Type PCI-E (x4) x 2 Input
Page 67 and 68: Connecting One GV-900A Card Here we
Page 71 and 72: Specifications 1 Video Capture Card
Page 73 and 74: Connecting One GV-650A / GV-800A Ca
Page 75 and 76: Connecting Two GV-650A / GV-800A Ca
Page 79 and 80:
Interface GV-650A x 2 GV-800A x 2 P
Page 81 and 82:
Connecting One GV-600A Card 1 Video
Page 83 and 84:
Connecting Two GV-600A Cards 1 Vide
Page 85 and 86:
Installing Drivers 1 Video Capture
Page 87 and 88:
1.11 GV-600B, GV-650B, GV-800B 1 Vi
Page 89 and 90:
Connecting Two GV-600B / GV-650B /
Page 91 and 92:
Installing Drivers 1 Video Capture
Page 93 and 94:
1 Video Capture Cards GV-600B x 2 G
Page 95 and 96:
• GV-600B, GV-650B, GV-800B Card
Page 97 and 98:
Video Capture Cards 1.14 Comparison
Page 99 and 100:
1 Video Capture Cards GV-4008A GV-4
Page 101 and 102:
1 Video Capture Cards GV-3008 GV-30
Page 103 and 104:
1 Video Capture Cards GV-600B GV-65
Page 105 and 106:
1 Video Capture Cards GV-1120B GV-1
Page 107 and 108:
1 Video Capture Cards GV-600B x 2 G
Page 109 and 110:
1 Video Capture Cards GV-1120B x 2
Page 111 and 112:
2.1 GV-Multi Quad Card 2 Hardware A
Page 113 and 114:
Connections with Two Video Capture
Page 115 and 116:
2.2 GV-Loop Through Card 2 Hardware
Page 117 and 118:
Connections with Two Video Capture
Page 119 and 120:
RS-485 Device Connections 2 Hardwar
Page 121 and 122:
2.4 GV-NET/IO Card V3.1 2 Hardware
Page 123 and 124:
2 Hardware Accessories 4. Ensure to
Page 125 and 126:
2 Hardware Accessories 2. You can c
Page 127 and 128:
2 Hardware Accessories 2. You can c
Page 129 and 130:
Extended Connections 2 Hardware Acc
Page 131 and 132:
2.5 GV-Hub V2 2 Hardware Accessorie
Page 133 and 134:
Extending Transmission over the Dis
Page 135 and 136:
2.6 GV-COM V2 2 Hardware Accessorie
Page 137 and 138:
Specifications OS Supported Serial
Page 139 and 140:
Connections 2 Hardware Accessories
Page 141 and 142:
2.8 GV-I/O 12-Out Card V3 2 Hardwar
Page 143 and 144:
Specifications OS Supported Output
Page 145 and 146:
Overview DIP Switch Figure 2-29 3 E
Page 147 and 148:
Assigning Addresses to GV-I/O Box 1
Page 149 and 150:
2 Hardware Accessories 3. Multiple
Page 151 and 152:
2.10 GV-I/O Box (8 Ports) 2 Hardwar
Page 153 and 154:
Connections There are three ways to
Page 155 and 156:
Extending Transmission over the Dis
Page 157 and 158:
Specifications Input Input 8 Input
Page 159 and 160:
Overview DIP Switch 1 ON A Wet Cont
Page 161 and 162:
Assigning Addresses to GV-I/O Box 4
Page 163 and 164:
2 Hardware Accessories 3. Multiple
Page 165 and 166:
2.12.1 Fixed IP Connection To assig
Page 167 and 168:
2 Hardware Accessories 2. In the Us
Page 169 and 170:
2.12.3 Other Setting In the left me
Page 171 and 172:
2.12.5 Output Setting In the left m
Page 173 and 174:
2.12.7 Updating Firmware To update
Page 175 and 176:
2.13 Installing USB Driver 2 Hardwa
Page 177 and 178:
3.1 Before You Start 3 Software Ins
Page 179 and 180:
Installing the System To install th
Page 181 and 182:
GeoVision Free Utility includes the
Page 183 and 184:
Chapter 4 Screen Overview This chap
Page 185 and 186:
The controls in the main screen: No
Page 187 and 188:
The controls in the ViewLog window:
Page 189 and 190:
4.3 SingleView Viewer 16 15 14 13 1
Page 191 and 192:
The controls in the MultiView Viewe
Page 193 and 194:
The controls in the Center V2 windo
Page 195 and 196:
Troubleshooting GV-System is design
show all

Installation Guide V8.5.6.0 - ApexCCTV

Create successful ePaper yourself

Delete template?

Save as template?