Installation Guide V8.5.6.0 - ApexCCTV

More documents

Recommendations

Info

Connecting Hardware Watchdog Insert the Hardware Watchdog Jumper Wire to the 2-pin connectors on the Card. The (+) pin on the Card must connect to the Reset (+) pin on the motherboard, and the (-) pin on the Card to the Ground (-) pin on the motherboard. Ensure the connection is correct; otherwise the hardware watchdog will be damaged. 26 GV-4008 Card Hardware Watchdog Figure 1-18 + - + - PC Reset Switch Note: To locate the motherboard’s Reset (+) pin and (-) pin, please refer to the motherboard’s user manual. RST HDD + _ PWSW LED Motherboard Front Panel Jumper
Installing Drivers 1 Video Capture Cards After installing the GV-4008 Card in the computer, insert the software DVD to install GV- Series drivers. The DVD will run automatically and an installation window will pop up. Select Install or Remove GeoVision GV-Series Driver, and select the following two options to install card and USB dongle drivers. • Install or Remove GeoVision GV-Series Card Drivers: installs card drivers. • Install GeoVision USB Device Drivers: installs USB dongle drivers. Note: For the installation of two GV-4008 cards, it is required to restart the computer after the driver is installed. To verify the drivers are installed correctly, go to Windows Device Manager and see if their entries are listed. The image below is an example of installing one GV-4008 card. Figure 1-19 Expand the DVR-Devices field, you can see: GV-4008 Card Entry Single-card mode Two-card mode GV4008 GV-Series USB Protector GV4008 GV4008 GV-Series USB Protector 27
Page 1 and 2: Installation Guide V8.5.6.0 Before
Page 3 and 4: Contents Important Notice..........
Page 5 and 6: Important Notice GPU Decoding Speci
Page 7 and 8: Frame rate limit in a single hard d
Page 9 and 10: 6. GV-600A, GV-650A and GV-800A:
Page 11 and 12: 1.1 GV-SDI-204 1 Video Capture Card
Page 13 and 14: Connecting Hardware Watchdog 1 Vide
Page 15 and 16: Adjusting the Video Settings in the
Page 17 and 18: Specifications GV-SDI-204 Interface
Page 19 and 20: Connecting One GV-5016 Card • Con
Page 23 and 24: Adjusting the Video Settings in the
Page 25 and 26: 1 Video Capture Cards 11. To adjust
Page 27 and 28: 1.3 GV-4008 1 Video Capture Cards T
Page 29: Connecting Two GV-4008 Cards 1 Vide
Page 33 and 34: 1 Video Capture Cards 2. Select the
Page 35 and 36: Specifications GV-4008 GV-4008 x 2
Page 37 and 38: Connecting One GV-4008A Card • Co
Page 41 and 42: Specifications GV-4008A GV-4008A x
Page 43 and 44: Connecting One GV-3008 Card • Con
Page 45 and 46: Video/Audio 1~4 Video/Audio 5~8 Vid
Page 47 and 48: Installing Drivers 1 Video Capture
Page 49 and 50: 1.6 GV-1120A, 1240A, 1480A 1 Video
Page 51 and 52: Connecting One GV-Combo A Card (D-T
Page 53 and 54: Connecting GV-NET/IO Card to GV-Com
Page 57 and 58: Specifications Interface Type PCI-E
Page 59 and 60: 1.7 GV-1120B, GV-1240B, GV-1480B 1
Page 61 and 62: Connecting Two GV-Combo B Cards 1 V
Page 65 and 66: Interface Type PCI-E (x4) x 2 Input
Page 67 and 68: Connecting One GV-900A Card Here we
Page 71 and 72: Specifications 1 Video Capture Card
Page 73 and 74: Connecting One GV-650A / GV-800A Ca
Page 75 and 76: Connecting Two GV-650A / GV-800A Ca
Page 79 and 80: Interface GV-650A x 2 GV-800A x 2 P
Page 81 and 82:
Connecting One GV-600A Card 1 Video
Page 83 and 84:
Connecting Two GV-600A Cards 1 Vide
Page 85 and 86:
Installing Drivers 1 Video Capture
Page 87 and 88:
1.11 GV-600B, GV-650B, GV-800B 1 Vi
Page 89 and 90:
Connecting Two GV-600B / GV-650B /
Page 91 and 92:
Installing Drivers 1 Video Capture
Page 93 and 94:
1 Video Capture Cards GV-600B x 2 G
Page 95 and 96:
• GV-600B, GV-650B, GV-800B Card
Page 97 and 98:
Video Capture Cards 1.14 Comparison
Page 99 and 100:
1 Video Capture Cards GV-4008A GV-4
Page 101 and 102:
1 Video Capture Cards GV-3008 GV-30
Page 103 and 104:
1 Video Capture Cards GV-600B GV-65
Page 105 and 106:
1 Video Capture Cards GV-1120B GV-1
Page 107 and 108:
1 Video Capture Cards GV-600B x 2 G
Page 109 and 110:
1 Video Capture Cards GV-1120B x 2
Page 111 and 112:
2.1 GV-Multi Quad Card 2 Hardware A
Page 113 and 114:
Connections with Two Video Capture
Page 115 and 116:
2.2 GV-Loop Through Card 2 Hardware
Page 117 and 118:
Connections with Two Video Capture
Page 119 and 120:
RS-485 Device Connections 2 Hardwar
Page 121 and 122:
2.4 GV-NET/IO Card V3.1 2 Hardware
Page 123 and 124:
2 Hardware Accessories 4. Ensure to
Page 125 and 126:
2 Hardware Accessories 2. You can c
Page 127 and 128:
2 Hardware Accessories 2. You can c
Page 129 and 130:
Extended Connections 2 Hardware Acc
Page 131 and 132:
2.5 GV-Hub V2 2 Hardware Accessorie
Page 133 and 134:
Extending Transmission over the Dis
Page 135 and 136:
2.6 GV-COM V2 2 Hardware Accessorie
Page 137 and 138:
Specifications OS Supported Serial
Page 139 and 140:
Connections 2 Hardware Accessories
Page 141 and 142:
2.8 GV-I/O 12-Out Card V3 2 Hardwar
Page 143 and 144:
Specifications OS Supported Output
Page 145 and 146:
Overview DIP Switch Figure 2-29 3 E
Page 147 and 148:
Assigning Addresses to GV-I/O Box 1
Page 149 and 150:
2 Hardware Accessories 3. Multiple
Page 151 and 152:
2.10 GV-I/O Box (8 Ports) 2 Hardwar
Page 153 and 154:
Connections There are three ways to
Page 155 and 156:
Extending Transmission over the Dis
Page 157 and 158:
Specifications Input Input 8 Input
Page 159 and 160:
Overview DIP Switch 1 ON A Wet Cont
Page 161 and 162:
Assigning Addresses to GV-I/O Box 4
Page 163 and 164:
2 Hardware Accessories 3. Multiple
Page 165 and 166:
2.12.1 Fixed IP Connection To assig
Page 167 and 168:
2 Hardware Accessories 2. In the Us
Page 169 and 170:
2.12.3 Other Setting In the left me
Page 171 and 172:
2.12.5 Output Setting In the left m
Page 173 and 174:
2.12.7 Updating Firmware To update
Page 175 and 176:
2.13 Installing USB Driver 2 Hardwa
Page 177 and 178:
3.1 Before You Start 3 Software Ins
Page 179 and 180:
Installing the System To install th
Page 181 and 182:
GeoVision Free Utility includes the
Page 183 and 184:
Chapter 4 Screen Overview This chap
Page 185 and 186:
The controls in the main screen: No
Page 187 and 188:
The controls in the ViewLog window:
Page 189 and 190:
4.3 SingleView Viewer 16 15 14 13 1
Page 191 and 192:
The controls in the MultiView Viewe
Page 193 and 194:
The controls in the Center V2 windo
Page 195 and 196:
Troubleshooting GV-System is design
show all

Installation Guide V8.5.6.0 - ApexCCTV

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?