Operator'sIVianual - Ppe-pressure-washer-parts.com
Operator'sIVianual - Ppe-pressure-washer-parts.com
Operator'sIVianual - Ppe-pressure-washer-parts.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Problem<br />
Pumphas following problems:<br />
failure to produce<strong>pressure</strong>,<br />
erratic <strong>pressure</strong>, chattering,loss<br />
of <strong>pressure</strong>, low water volume.<br />
Detergentfails to mix with spray.<br />
Enginerunsgoodat no-load but<br />
"bogs" when load is added.<br />
Enginewill not start; or startsand<br />
runs rough.<br />
Cause<br />
1. Water inlet is blocked.<br />
2. inadequatewater supply.<br />
3. inlet hose is kinkedor leaking.<br />
4. Clogged inlet hose strainer.<br />
5. Water supply is over IO0°F.<br />
6. High <strong>pressure</strong> hose is blocked or<br />
leaks.<br />
7. Gun leaks.<br />
8. Spray tip is obstructed.<br />
9. Pump is faulty.<br />
1. Detergentsiphoning tube is not<br />
submerged.<br />
2. Detergentsiphoning tube/filter is<br />
clogged or cracked.<br />
3. High <strong>pressure</strong> spray tip installed.<br />
Engine speed is too slow.<br />
1. Throttle lever in "Stop" position.<br />
2. Fuel valve in "Off" position.<br />
3. Dirty air cleaner.<br />
4. Out of fuel.<br />
5. Stale fuel.<br />
6. Spark plug wire not connected to<br />
spark plug.<br />
7. Badspark plug.<br />
8. Water in fuel.<br />
9. Overchoking.<br />
10. Excessivelyrich fuel mixture.<br />
Correction<br />
1. Cieariniet.<br />
2. Provide adequatewater flow.<br />
i<br />
i3. Straighten inlet hose, patch leak.<br />
4. Checkand clean inlet hose strainer.<br />
5. Provide cooler water supply.<br />
6. Clear blocks in high <strong>pressure</strong> hose or<br />
replace hose.<br />
7. Replacegun.<br />
8. Cleanspray tip.<br />
9. Contact Sears service facility.<br />
1. insert detergent siphoning tube into<br />
detergent.<br />
2. Cleanor replacefilter/detergent<br />
siphoning tube.<br />
3. Replacehigh <strong>pressure</strong> spray tip with<br />
black spray tip.<br />
Move throttle control to FASTposition, if<br />
engine still "bogs down", contact Sears<br />
service facility.<br />
1. Move throttle lever to "Fast" position.<br />
2. Move fuel valve to "On" position.<br />
3. Cleanor replaceair cleaner.<br />
4. Fill fuel tank.<br />
5. Drain fuel tank; fill with fresh fuel.<br />
6. Connect wire to spark plug.<br />
7. Replacespark plug.<br />
i<br />
i8. Drain fuel tank; fill with fresh fuel.<br />
9. Openchoke fully and crank engine.<br />
10. Contact Sears service facility.<br />
Engineshutsdown during Out of fuel. Fill fuel tank.<br />
operation.<br />
Engine Jackspower.<br />
Engine "hunts" or falters.<br />
Dirty air filter.<br />
Choke is openedtoo soon.<br />
Replaceair filter.<br />
Move choke to halfway position until engine<br />
runs smoothly.<br />
22