aquecedor de biberões chauffe-biberon feeding bottle ... - Neo Baby

as described in the paragraph above,
place the feeding bottle warmer on a flat,
stable surface and connect the plug to a
mains socket.
• Select the feeding bottle warming mode,
pointing the knob to the “feeding bottle”
icon. If the equipment is connected to the
mains, the red warning light will indicate
that the feeding bottle warmer is warming
up the bottle. When the food reaches
the correct temperature, a green light will
switch on and the equipment will emit an
acoustic signal.
• The heating time can vary a lot, depending
on the type/size of the feeding bottle,
the type, quantity and initial temperature
of the food inside the feeding bottle.
• To switch off the feeding bottle warmer at
any time, turn the knob to the “0” icon,
and disconnect the power cable’s plug
from the mains socket.
• Warning! Before feeding baby, it is recommended
to:
1. Dry the feeding bottle thoroughly.
2. Shake the feeding bottle for a few seconds
in order to homogenise the temperature
of the food inside.
3. Always check that the temperature of
the food is not too hot before feeding
baby (by pouring a few drops of liquid
on the inner of part your wrist).WARN-
ING: If the feeding bottle is left into the
equipment for more than 15 minutes,
the temperature of the food inside the
feeding bottle may reach a temperature
of over 50°C. Always check that the
temperature of the food before feeding
baby.
How to warm up baby food jars:
• Repeat the operations indicated at the beginning
of the “How to Prepare the Equipment”
paragraph.
• Insert the baby food jar into the feeding
bottle chamber, placing it onto the support.
• Place the feeding bottle warmer onto a
flat, stable surface, and connect the plug
to a mains socket.
• Fill the space between the baby food jar
and the inner surface of the feeding bottle
warmer with water, up to approximately 1
17
cm from the upper rim of the baby food
jar.
• Select the baby food jar warming mode,
turning the knob towards the “baby food
jar” icon. The red warning light will indicate
that the equipment is warming up the
jar. When the food reaches the correct
temperature, a green light will switch on
and the equipment will emit an acoustic
signal.
• After approximately 5 minutes, check the
temperature of the food inside in the jar.
If the food is at the correct temperature,
switch off the feeding bottle warmer, turning
the knob towards the “0” icon, then
disconnect the power cable plug from the
mains socket. If the temperature is still too
cold, continue the warming up cycle, taking
care to check often the temperature of
the blended food.
• Warning: The feeding bottle warmer must
always be switched off and allowed to
cool down completely after one hour of
continuous operation before being used
again.
• Warning: when the baby food jar warming
mode is selected, the temperature of the
food inside the jar may reach a very high
temperature (even higher than 70°C).
Always check that the temperature of the
food before feeding baby.
• To switch off the feeding bottle warmer at
any time, turn the knob towards the “0”
icon, and disconnect the power cable’s
plug from the mains socket.
• Warning: During the warming up cycle,
it is recommended to often stir the jar’s
content, in order to homogenise the temperature.
• Warning: Before feeding baby, it is recommended
to:
1. Dry the baby food jar thoroughly.
2. Stir the jar’s content for a few seconds,
in order to homogenise the food temperature
3. Always check that the temperature of
the food is not too hot before feeding
baby (by pouring a few drops of liquid
on the inner of part your wrist).
WARNING:
Always let the feeding bottle warmer cool