2. Specifications - Albatross Control System

More documents

Recommendations

Info

3.<strong>2.</strong><strong>2.</strong> Module location when the vessel contains analogue gauges Alba-Engine has two kinds of connections: 1 – To the motor sensors 2 – To the NMEA 2000 network Thus, it should be connected between the main NMEA-2000 network and the analogue gauges. This is because you’ll have to connect some cables to the back of these gauges, and the interface to the NMEA network. Emmi network recommends putting Alba-Engine at a maximum distance of 4 metres from the analogue gauges. It can also be connected to a maximum distance of 6 metres from the NMEA network, although the boat-owner may consider installing it closer to the main NMEA network in order to save on the cost of cable. Interface install location is not critical, and taking into account that all NMEA cables and connector are watertight (IP 67: protection against temporary immersions in water), the interface could be placed virtually anywhere on the vessel. 10
Figure 3. Connection diagram of the module in parallel with analogue gauges 11
Page 1 and 2: USER MANUAL MANUAL DE USUARIO Alba-
Page 3 and 4: Document revisions Revision Date Co
Page 5 and 6: 1. Introduction Thanks for purchasi
Page 7 and 8: 3. Quick installation To install th
Page 9: Thus, the Alba-Engine interface sho
Page 13 and 14: 3.3.1 Alba-Engine connection to a m
Page 15 and 16: 3.3.2 Alternator and mass connectio
Page 17 and 18: 3.3. 4 Connection to NMEA 2000 bus
Page 19 and 20: Figura 15B. Connection diagram of t
Page 21 and 22: 3.4.1 NMEA instance number and addr
Page 23 and 24: 3.4.1.3 Choice of parameters to be
Page 25 and 26: 3.4.2 Sensor calibration and commer
Page 27 and 28: 3.7 Technical specifications SPECIF
Page 30 and 31: Revisiones del documento Revisión
Page 32 and 33: 1. Introducción Gracias por adquir
Page 34 and 35: 3. Instalación Para instalar el in
Page 36 and 37: El lugar de colocación del interfa
Page 38 and 39: Figura 3. Esquema de conexión del
Page 40 and 41: 3.3.1 Conexiones del Alba-Engine a
Page 42 and 43: 3.3.2 Conexiones al alternador y ma
Page 44 and 45: 3.3. 4 Conexión al bus NMEA2000 EL
Page 46 and 47: Figura 15B. Esquema de conexión de
Page 48 and 49: 3.4.1 Número de instancia y direcc
Page 50 and 51: 3.4.1.3 Selección de los parámetr
Page 52 and 53: 3.4.2 Calibración del sensor y sel
Page 54 and 55: 3.7 Especificaciones técnicas ESPE

2. Specifications - Albatross Control System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?