2. Specifications - Albatross Control System

More documents

Recommendations

Info

3.3.1 .2 Connection to a pressure or temperature gauge You'll need to unscrew the connector’s nut in these gauges and hook a new cable to be connected to either the 4, 6, 8 or 10 inputs in the Alba-Engine. Gauge terminals Proposed cable colour Tensión (+, +12V, I, IGN) Red Ground (-, ⊥,G) Black Sensor (S, G) Green Figure 6. Wiring diagram of the module to a VDO pressure or temperature analogue gauge. 14
3.3.2 Alternator and mass connection To connect the alternator’s input and measure the incoming voltage from it, you’ll need to connect a cable to the +V connector in the voltmeter gauge. If your motor’s control panel has no voltmeter, locate the alternator’s connection to the battery bank. Figure 7. Wiring diagram from the module to a VDO voltmeter 15
Page 1 and 2: USER MANUAL MANUAL DE USUARIO Alba-
Page 3 and 4: Document revisions Revision Date Co
Page 5 and 6: 1. Introduction Thanks for purchasi
Page 7 and 8: 3. Quick installation To install th
Page 9 and 10: Thus, the Alba-Engine interface sho
Page 11 and 12: Figure 3. Connection diagram of the
Page 13: 3.3.1 Alba-Engine connection to a m
Page 17 and 18: 3.3. 4 Connection to NMEA 2000 bus
Page 19 and 20: Figura 15B. Connection diagram of t
Page 21 and 22: 3.4.1 NMEA instance number and addr
Page 23 and 24: 3.4.1.3 Choice of parameters to be
Page 25 and 26: 3.4.2 Sensor calibration and commer
Page 27 and 28: 3.7 Technical specifications SPECIF
Page 30 and 31: Revisiones del documento Revisión
Page 32 and 33: 1. Introducción Gracias por adquir
Page 34 and 35: 3. Instalación Para instalar el in
Page 36 and 37: El lugar de colocación del interfa
Page 38 and 39: Figura 3. Esquema de conexión del
Page 40 and 41: 3.3.1 Conexiones del Alba-Engine a
Page 42 and 43: 3.3.2 Conexiones al alternador y ma
Page 44 and 45: 3.3. 4 Conexión al bus NMEA2000 EL
Page 46 and 47: Figura 15B. Esquema de conexión de
Page 48 and 49: 3.4.1 Número de instancia y direcc
Page 50 and 51: 3.4.1.3 Selección de los parámetr
Page 52 and 53: 3.4.2 Calibración del sensor y sel
Page 54 and 55: 3.7 Especificaciones técnicas ESPE

2. Specifications - Albatross Control System

Create successful ePaper yourself

Delete template?

Save as template?