2. Specifications - Albatross Control System

More documents

Recommendations

Info

3.4.1.4 Choice of sensor type As seen in section 2, motor sensors are either resistive or voltage-based (VDO). You must choose the appropriate type of sensor connected for each parameter to be measured. Once you have changed all the necessary fields in the dialog box, click “Accept” for all information to be programmed and stored in the Alba-Engine interface’s memory. Figure 2<strong>2.</strong> Detail of the sensor type (resistive or VDO) configuration field 24
3.4.2 Sensor calibration and commercial brand choice Once sensor and measure units have been chosen, it’s time to click on the “Calibrate” button for inputs 2 to 5. On pushing it, a new window will open where you can choose the sensor gauge’s brand and model to follow. 3.4.<strong>2.</strong>1 Sensor type This is one of the most important steps in the configuration of your Alba-Engine unit, as each commercial gauge and sensor has its own specific configuration, and proper configuration of these is fundamental to ensure the accuracy of its measurements. Figure 23. Dialog box for calibration points in a sensor. 25
Page 1 and 2: USER MANUAL MANUAL DE USUARIO Alba-
Page 3 and 4: Document revisions Revision Date Co
Page 5 and 6: 1. Introduction Thanks for purchasi
Page 7 and 8: 3. Quick installation To install th
Page 9 and 10: Thus, the Alba-Engine interface sho
Page 11 and 12: Figure 3. Connection diagram of the
Page 13 and 14: 3.3.1 Alba-Engine connection to a m
Page 15 and 16: 3.3.2 Alternator and mass connectio
Page 17 and 18: 3.3. 4 Connection to NMEA 2000 bus
Page 19 and 20: Figura 15B. Connection diagram of t
Page 21 and 22: 3.4.1 NMEA instance number and addr
Page 23: 3.4.1.3 Choice of parameters to be
Page 27 and 28: 3.7 Technical specifications SPECIF
Page 30 and 31: Revisiones del documento Revisión
Page 32 and 33: 1. Introducción Gracias por adquir
Page 34 and 35: 3. Instalación Para instalar el in
Page 36 and 37: El lugar de colocación del interfa
Page 38 and 39: Figura 3. Esquema de conexión del
Page 40 and 41: 3.3.1 Conexiones del Alba-Engine a
Page 42 and 43: 3.3.2 Conexiones al alternador y ma
Page 44 and 45: 3.3. 4 Conexión al bus NMEA2000 EL
Page 46 and 47: Figura 15B. Esquema de conexión de
Page 48 and 49: 3.4.1 Número de instancia y direcc
Page 50 and 51: 3.4.1.3 Selección de los parámetr
Page 52 and 53: 3.4.2 Calibración del sensor y sel
Page 54 and 55: 3.7 Especificaciones técnicas ESPE

2. Specifications - Albatross Control System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?