ULTRAMAT 14 plus - Graupner

More documents

Recommendations

Info

NiMH ________________ manual 34 ________________ C:2.5A + - INC DEC NiMH ________________ balance cut off ________________ volt = 1.20V START Ni-MH manual program Select this program when you simply wish to recharge a battery using the set charge current. You can adjust the charge current using the INC / DEC buttons, but only before you connect the pack for charging. The range available is 0.1 A to 5 A. Never use a maximum charge current higher as the value described in the battery instruction, never higher as 2C! Never charge transmitter batteries with more as 2A! f. e. a 4.2Ah battery should be limited to max. 4.2A. The charge process is terminated automatically in accordance with the values already set for „Ni-MH Delta Peak cut-off voltage“. Ni-MH discharge balancing program 2 sec. + - INC DEC **INFORMATION*** ________________ BALANCER ________________ CON. 2 sec. ________________ BLC 28:30 0<strong>14</strong>25 ________________ NM+0.00A 07.717V The balancing program does balance up to 6 cells of a battery pack. The final discharge voltage for the balancer can be set within the range 1.20 … 1.30 V using the INC or DEC button. The individual cells in a battery should be balanced before the pack is charged, to avoid the possibility of individual cells being overcharged during the charge process. A battery should always be balanced before being charged if it has been stored for a considerable period; connect the balancer plug to the charger to carry this out. It is also essential that the voltage of each cell in the pack should be higher than the set balancer final discharge voltage. If you wish to obtain maximum battery capacity, the individual cells should be discharged to 1.20 V a few hours - but no longer than two hours - before the next charge process. If the voltage falls below 1.20 V, the battery cells lose capacity, so the pack must be charged to around 60% capacity before being stored for a protracted period. The program balances the battery pack. Cells with a higher cell voltage are discharged at around 100 mA (balancing current). The charger terminates the discharge balance process once all the cells have reached the balancer final discharge voltage (+0.01 V).
Ni-MH-Delta-Peak (-∆ Peak) trigger voltage NiMH ________________ delta-peak- ________________ volt = 5mV/cell + - INC DEC It is possible to adjust the trigger voltage (in mV per cell!) of the automatic termination circuit for Ni-MH batteries. However, Ni-MH batteries have a less pronounced voltage drop than Ni-Cd cells, and a practical range has proved to be 5 ... 25 mV / cell. If the trigger voltage is set higher, there is a danger of overcharging the battery; if set lower, there is a danger of premature termination. We recommend that you carry out a series of test charges to establish the ideal trigger value for your batteries. Start with 5mV / cell. 35
Page 1 and 2: BEDIENUNGSANLEITUNG OPERATING MANUA
Page 3 and 4: Sicherheits- und Warnweise Das Lad
Page 5 and 6: Haftungsausschluss Die Einhaltung d
Page 7 and 8: NiCd AUTOMATIK Programm MODE (2 sek
Page 9 and 10: NiCd AUTOMATIK- Programm 11. NiCd-P
Page 11 and 12: NiMH AUTOMATIK- Programm 12. NIMH-P
Page 13 and 14: NiMH-Delta-Peak (-∆ Peak) Ansprec
Page 15 and 16: LiPo-Manuell ________________ _____
Page 17 and 18: Pb-Manuell ________________ _______
Page 19 and 20: Anzeige der Eingangsspannung und de
Page 21 and 22: ________________ *****FEHLER***** _
Page 23 and 24: 20. Technische Daten Akku: Ladestr
Page 25 and 26: 2. Warnings and safety notes This
Page 27 and 28: Liability exclusion As manufacturer
Page 29 and 30: NiCd AUTOMATIC program MODE (2 sec.
Page 31 and 32: NiCd AUTOMATICprogram 11. Ni-Cd pro
Page 33: NiMH AUTOMATICprogram 12. NIMH-prog
Page 37 and 38: LiPo ________________ manual ______
Page 39 and 40: Pb ________________ manual ________
Page 41 and 42: INC Input voltage and Battery resis
Page 43 and 44: ________________ *****ERROR****** _
Page 45 and 46: 20. Specification Battery: Charge c
Page 47 and 48: 2. Avertissements et conseils de s
Page 49 and 50: Exclusion de responsabilité : Le r
Page 51 and 52: 8. Sélection des groupes de progra
Page 53 and 54: NiCd Programme Automatique 11. Prog
Page 55 and 56: NiMH Programme Automatique 12. Prog
Page 57 and 58: NiMH ________________ Delta-Peak- _
Page 59 and 60: LiPo-Manuel ________________ ______
Page 61 and 62: Pb-Manuel ________________ ________
Page 63 and 64: Affichage de la tension d‘ entré
Page 65 and 66: ________________ *****ERREUR***** _
Page 67 and 68: 20. Caractéristiques techniques Ac
Page 69 and 70: Indice Capitolo Pagina 1 11. 1 Gene
Page 71 and 72: 3. Notizie generali per funzionamen
Page 73 and 74: 6. Programmi carica Le diverse poss
Page 75 and 76: 3 sec. LiPo-Manuell _______________
Page 77 and 78: NiCd Balancerspannung (Programma Te
Page 79 and 80: NiMH-Manuell ________________ _____
Page 81 and 82: 13. Programmi Litio Programmi sono
Page 83 and 84: Lithium ________________ Typ LiPo _
Page 85 and 86:
Programma Tipo accumulatore 15. Ind
Page 87 and 88:
17. Segnalazioni di errore ed avver
Page 89 and 90:
18. Pulizia e manutenzione Il caric
Page 91 and 92:
Konformitätserklärung / Conformit
show all

ULTRAMAT 14 plus - Graupner

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?