Installation instructions - Fisher & Paykel
Installation instructions - Fisher & Paykel
Installation instructions - Fisher & Paykel
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
US<br />
CA<br />
(EN)<br />
20 Using your cooktop<br />
Auto-reignition is for your convenience and safety. The auto-reignition feature causes the<br />
ignitors to spark automatically and the burner to relight if a flame blows out or if the flame is<br />
severely distorted by a draft or a cooktop ventilation system.<br />
Constant sparking<br />
The ignitors must be kept clean and dry to work<br />
correctly. Dirty or wet ignitors could cause constant<br />
sparking, even if a flame is present.<br />
(See ‘Troubleshooting’).<br />
If the burner has an inconsistent flame or does not light<br />
If the gas does not light within four seconds, turn the dial to OFF. Allow at least two minutes<br />
for the gas to disperse before trying again.<br />
Check that the power to the product is switched on.<br />
Check that the burner parts are assembled correctly as below:<br />
Power failure<br />
Ignitors can be kept<br />
clean with a small brush<br />
and rubbing alcohol.<br />
Correct assembly Incorrect assembly<br />
In the event of a power failure, turn all burner control dials to OFF. The burners can be lit by<br />
holding a lighted match close to the side of the burner and turning the control dial to HI. Wait<br />
until the flame is burning all the way around the burner cap before adjusting.
Change language