Stinson Reliant SR-10 BNF/PNP - HobbyTown USA
Stinson Reliant SR-10 BNF/PNP - HobbyTown USA
Stinson Reliant SR-10 BNF/PNP - HobbyTown USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>PNP</strong> Installation<br />
ONLY<br />
EN<br />
Note: The information on this page is for maintenance of the<br />
<strong>Stinson</strong> <strong>Reliant</strong>. Damage to these parts can result from aircraft<br />
crashes. Installation of the motor is in reverse order of the<br />
steps listed below. The propeller (PKZ<strong>10</strong>12) must be removed<br />
from the motor (PKZ4416) before the cowl and motor can be<br />
removed from the aircraft.<br />
3. Remove four (4) screws from the motor mount (PKZ4428) and<br />
the fuselage.<br />
CAUTION: DO NOT handle the motor or ESC while the<br />
flight battery is connected to the ESC. Personal injury<br />
could result.<br />
1. Remove three (3) screws from the cowl.<br />
2. Carefully remove the cowl from the fuselage.<br />
Range Check and Pre-Flying Tips<br />
4. Remove the three (3) motor wire connectors from the ESC<br />
wire connectors (wire colors are aligned between the motor<br />
and the ESC).<br />
5. Remove four (4) screws from the motor mount and motor<br />
(PKZ4416).<br />
6. When wires for the ESC are disconnected in the fuselage, the<br />
ESC can be removed.<br />
Installing a Receiver<br />
1. Install your park flyer or full range receiver in the<br />
fuselage using hook and loop tape or double-sided servo<br />
tape.<br />
2. Attach the elevator and rudder servo connectors to the<br />
appropriate channels of the receiver.<br />
3. Attach the aileron Y-harness to the aileron channel of<br />
the receiver.<br />
4. Attach the ESC connector to the throttle channel of the<br />
receiver.<br />
Battery Selection and Installation<br />
• We recommend the ParkZone 1800mAh 11.1V 15C<br />
Li-Po battery (PKZ<strong>10</strong>29).<br />
• If using another battery, the battery must be at least a<br />
15C 1800mAh battery.<br />
• Your battery should be approximately the same<br />
capacity, dimensions and weight as the ParkZone<br />
Li-Po battery to fit in the fuselage without changing<br />
the center of gravity a large amount.<br />
17