ecoLEVEL - Plumb Traders
ecoLEVEL - Plumb Traders
ecoLEVEL - Plumb Traders
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4 Mounting<br />
4 Mounting<br />
4.3 Dimensions and clearances<br />
4.1 Scope of delivery<br />
min. 5 mm<br />
min. 5 mm<br />
Description Dimensions Quantity<br />
Condensate pump 180 x 160 x 100 mm 1<br />
Wall plugs 5 mm 2<br />
min. 200 mm<br />
Screws 4 x 35 mm 2<br />
Feed hose Ø 24 mm x 1.15 m 1<br />
Discharge hose Ø 10 mm x 6 m 1<br />
Wall bracket - 1<br />
115 mm<br />
150 mm<br />
Wall bracket for drain hose - 6<br />
Operating, Installation, and<br />
maintenance manuals<br />
Table 4.1 Scope of delivery<br />
- 1<br />
The following tools are required for installation:<br />
- Drill<br />
- Drill bit (5 mm)<br />
- Slot head screwdriver<br />
- Water-level<br />
- Cutting blade<br />
- Tools for making electrical connections<br />
min. 200 mm<br />
min. 5 mm<br />
165 mm<br />
175 mm<br />
min. 5 mm<br />
4.2 Selecting the installation site<br />
The <strong>ecoLEVEL</strong> condensate pump should be installed in<br />
the room where the boiler is located.<br />
The ambient room temperature must be between 5 °C<br />
and 60 °C.<br />
The pump should be fixed to a wall that is suitable for<br />
installation using the provided mounting hardware. If a<br />
suitable wall is not available, a suitable mounting surface<br />
must be prepared.<br />
The <strong>ecoLEVEL</strong> condensate pump should not be used as<br />
a storage shelf.<br />
90 mm<br />
100 mm<br />
Fig. 4.1 Dimensions and installation spaces<br />
4.4 Installing the wall bracket<br />
• Slide the pre-assembled wall bracket downward and<br />
out of the condensate pump housing.<br />
• Install the wall bracket (as shown in Fig. 4.2) in a suitable<br />
position below the point where the condensate<br />
drains out of the boiler.<br />
The wall bracket must be installed in a level position!<br />
Use a spirit-level!<br />
• From above, slide the condensate pump straight down<br />
along the guiding edges of the wall bracket.<br />
A small hook at the lowest position catches the pump<br />
and secures it in the wall bracket.<br />
Note!<br />
The condensate pump can be fastened to the<br />
wall bracket (as shown in Fig. 4.1) either on its<br />
narrow or on its wide side.<br />
4 Installation and maintenance manual <strong>ecoLEVEL</strong>