Installation Manual Ascent IIâ¢ Toilet Pumping System - PEX Universe

More documents

Recommendations

Info

4-3-2 Discharge and Vent Flanges: Both the discharge and vent flanges are fastened to the main cover and can be removed by unscrewing the four fasteners and pulling the flange away from the main cover. 4-3-3 Check Valve: The discharge flange has an integrated check valve. The valve is held in place by a support backing plate that is also connected to the discharge hose. To access the check valve, first remove the discharge flange from the main cover by removing 4 screws. Then, remove the hose followed by the two screws. The hose nipple can then be separated from the flange by pulling it outward. The check valve snaps onto the hose nipple. When reinstalling, the hinge of the check valve must be aligned with the “notch” in the hose nipple or backing plate. After installation of the hose nipple, confirm the check valve opens completely. ©Copyright 2011 Liberty Pumps Inc. All rights reserved. 10
4-3-4 Access cover: The access cover is secured to the main cover with five fasteners. If required, use the 3/16 Allen wrench supplied to loosen the fasteners. Once the screws have been removed, the access cover can be lifted upward. Some manipulation might be necessary if the Macerator is located directly under the toilet’s reservoir tank. Once the access cover is removed pull the power cartridge towards opening a) Once the access cover is removed, the power cartridge can be slid towards the opening by grasping the handle of the basket and pulling to the right towards the opening. In some instances, debris might be caught between the tank and the basket so some manipulation might be required. b) With the power cartridge fully slid over, the cutters should be in view at the center of the basket. Any obstruction or object can be removed at this point. The cutters are very sharp and extreme caution should be used. c) To replace the cutters the 3/16 Allen wrench (supplied) should be inserted into one of the holes located on the basket floor. This will create a wedge preventing the blade assembly from turning. The locking fastener can be unscrewed with the use of a 7/16” socket (1/4” drive). Once loose, the screw and cap can be removed by pulling upward which exposes the two razor blades. Liberty Pumps recommends stainless steel blades, although any common utility knife style razor blade with two holes can be used as a replacement. When replacing the razor blades simply insert the blade onto the two pins. The cap and screw should then be replaced. d) The base of the cutting cartridge can be replaced as well. After removing the razor blades a thin slotted screwdriver can be inserted into the center hole and once engaged the base can be rotated counterclockwise until it is free. To remove cap Unscrew fastener Screw Cap Utility blade Base Place Allen wrench in hole to prevent cutter from turning Cutting and health hazard, caution must be used when handling razor blades. ©Copyright 2011 Liberty Pumps Inc. All rights reserved. 11
Page 1 and 2: Installation Manual 5755000A Ascent
Page 3 and 4: 1-2 STORAGE BEFORE USE Liberty prod
Page 5 and 6: 3-2 PREPARING THE MACERATING PUMP U
Page 7 and 8: 3-5-3 If you wish the unit to pump
Page 9: 3-8-13 ELECTRICITY The macerating s
Page 13 and 14: 4-3-7 Interconnect hose: A hose con
Page 15 and 16: Toilet flushes normally but does no
Page 17 and 18: Water backs up into shower tray •
Page 19 and 20: Manual de instalación 5755000A Sis
Page 21 and 22: 1-2 ALMACENAMIENTO ANTES DEL USO Lo
Page 23 and 24: VENTILACIÓN DESAGÜE VENTILACIÓN
Page 25 and 26: 3-5-3 Si se desea que la unidad bom
Page 27 and 28: 3-8-13 ELECTRICIDAD El macerador de
Page 29 and 30: 4-3-4 Tapa de acceso La tapa de acc
Page 31 and 32: 4-3-7 Manguera de interconexión: U
Page 33 and 34: El inodoro desagua normalmente pero
Page 35 and 36: El agua se devuelve hacia la plataf
Page 37 and 38: Manuel d’installation 5755000A Sy
Page 39 and 40: 1-2 ENTREPOSAGE AVANT UTILISATION L
Page 41 and 42: ÉVENT ÉVACUATION ÉVENT ÉVACUATI
Page 43 and 44: 3-5-3 Lorsque la pompe aspire à la
Page 45 and 46: 3-8-11 ÉVACUATION Ne jamais évacu
Page 47 and 48: 4-3-4 Couvercle d’accès : Le cou
Page 49 and 50: 4-3-7 Tuyaux d’interconnexion : u
Page 51 and 52: La chasse d’eau fonctionne normal
Page 53 and 54: L’alarme se déclenche souvent. L
Page 55: 7. Garantie limitée de 2 ans *REMA

Installation Manual Ascent IIâ¢ Toilet Pumping System - PEX Universe

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Installation Manual Ascent IIâ¢ Toilet Pumping System - PEX Universe