Receiver Ampli-Tuner - Yamaha Hifi

PLAYING AND RECORDINGRecording a sourceNotes• Audio signals are not output to the TAPE REC or LINE 1 RECoutput jacks when TAPE or LINE 1 is selected with the RECOUT selector.Audio signals are output to both the TAPE REC and the LINE 1REC output jacks if when PHONO, DOCK, TUNER, CD,SOURCE or LINE 2 is selected with the REC OUT selector.• This unit must be turned on in order to record.• The VOLUME, BASS, TREBLE, BALANCE andLOUDNESS controls and the CD DIRECT AMP switch (R-S700 only) and the PURE DIRECT switch have no effect on thesource being recorded.• Check the copyright laws in your country before recording fromrecords, CDs, radio, etc. Recording copyright-protectedmaterial may infringe on copyright laws.Using the sleep timerUse this feature to automatically set this unit to standbymode after a certain amount of time. The sleep timer isuseful when you are going to sleep while this unit isplaying or recording a source.A (power)REC OUT selectorINPUT selector1 Rotate the REC OUT selector on the frontpanel to select the source you want torecord.When SOURCE is selected, the current input sourceis output.2 Play the source and begin recording usingthe recording device connected to the RECjacks (TAPE and/or LINE 1) on the rear panel.See page 10.NoteRECEIVER ASLEEPThe sleep timer can only be set with the remote control.1 Press SLEEP repeatedly to set the amount oftime before this unit is set to standby mode.Each time you press SLEEP, the front panel displaychanges as shown below.The SLEEP indicator blinks while setting the amountof time for the sleep timer.If the sleep timer is set, the SLEEP indicator on thefront panel display lights up.yTo cancel the sleep timer, do one of the following:• Select “Sleep Off”.• Press RECEIVER A on the remote control to set this unit tostandby mode.• Press A (power) on the front panel to turn off this unit.BASICOPERATION English17 En