Vi-Go Systems Manual - Miller Fall Protection

More documents

Recommendations

Info

User Instructions - English5.5 Installation of Cableand Tensioning Assemblyto Bottom Bracket AssemblyFig. 61. Install saddle clips loosely around cable attachedto tension rod (see Fig. 6).2. Slide the tension rod down the cable and throughamount of threads are through to install thecompression spring, washer and tensioning nut.3. Remove excess cable by pulling cable through thesaddle clips. Tighten and torque saddle clips to40 to 45 ft. lbs.4. Tighten tensioning nut until cable is taut.achieved. Do not completely compress spring.repeat procedure from Step 3.5. When proper tensioning of cable is achieved,install jam nut against tensioning nut.6. Discard excess cable by cutting below the lowerSaddleClipTensionRodCompressionSpringWasher5-1/2"TensioningNutJam NutAssembly withTensioning Assembly andCable Installedrequired. Using a hand punch, designate the appropriate system capacity rating, installation date and service/inspection dates using the spaces provided on the label. Attach the label to the ladder or structure with the nylontie provided. Attach the label to the system where it is easily accessible to anyone using the system. Record12
User Instructions - English5.6 Options for Terminating Cable in the Fieldfor increased versatility during installation to accommodatevariable cable lengths. These options are compatiblewith 3/8” diameter approved cable only.Thimble and Wire RopeCable Termination Kit (VGTWC)1. Feed cable around cable thimble, turning back 5-1/4" of cable fromthimble end. dead end of rope. Use torque wrench to tighten evenly, alternatingfrom one nut to the other until reaching a torque of 45 ft. lbs.2. Install second cable clip as close to the thimble as possible. Again,use torque wrench to tighten evenly to 45 ft. lbs.1 Clip Base Width (1-1/8")from Dead EndDead EndCompletely AssembledLive EndFast-Attach Fitting for 3/8” Diameter Approved Cable (VGF-1)*Wedge Set includes three toothedwedges and retaining ring.13
Page 5 and 6: User Instructions - English3.0 Syst
Page 7 and 8: User Instructions - English4.2 Vi-G
Page 9 and 10: User Instructions - English5.1 Inst
Page 11: User Instructions - EnglishMANUAL P
Page 15: User Instructions - English8.0 Insp
Page 18 and 19: Directives d'utilisation - Françai
Page 31 and 32: Instrucciones Para El Usuario - Esp
Page 45 and 46: Inspection and Maintenance LogRegis
Page 47 and 48: MILLER ® At Honeywell Safety Produ

Vi-Go Systems Manual - Miller Fall Protection

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?