NX242 Digital TDcontroller - Nexo

MENU DESCRIPTIONPAGE 23ENGLISH2.6 AMP GAINAdjustable from 20dB to 40dB nominal Amp Gain in 0.5dBsteps for each channel.See in “ Amplifiers (Gain, Power)” page 25 a completedescription of this menu, and the way to adjust this setting.2.7 AMP POWERAllows you to enter a Nominal Amp RMS power into8ohms. Adjustable from 200 Watts to 5000 Watts in 50Wsteps for each channel.See in “ Amplifiers (Gain, Power)” page 25 a completedescription of this menu, and the way to adjust this setting.2.8 Reset measure & Sense AlertThe first section of Menu 2.8 allows you to reset the gainand power reading to default settings. If the ENTERbutton is pressed, the values are reset, and menu 2.6is displayed again. Use this feature if any physical changeshave occurred in your system to start again themeasurement process.Turn the encoder wheel to reach the second section ofMenu 2.8, which is the alert disable menu. Press the enter button to set the alerts (Led flashing) on or off. Oncedisabled, the LEDs will not flash if gain settings areincorrect. This parameter is saved every time the NX242returns to the default screen, or when a setup is saved inthe menu 1.5.Configuration select.3.1 System Config.Changing a set of parameters within the same family ismade immediately and is barely audible.USER MANUAL LOAD2_22DATE: 03/12/2004