A910-24 - Cbe

ELECTRONIC BATTERY CHARGER “A 910-24”1ELEKTRONISCHES BATTERIE-LADEGERÄTGel27,6V 28,8V+ +24VSPb2 3Mod. A 910-24Eingang 230V 50 HzNennleistung 150VAAusgang 24V 5AStromüberwachung>40 Ah ta40/E 110°C24VI0by230 V4Ortsfest in trockenem Raum einbauenVor dem Laden Gebrauchsanweisung lesen!Made in ItalyLEGENDA1) Commutator to choose the connected battery: “Pb” lead-acid battery, “Gel” gel-battery.If the commutator is set wrongly, you can damage the leisure battery.2) Connector for the connection of the battery.3) N.C.4) 230V on/off safety switch; it can be always on.FUNCTIONSIt was studied to charge starter (lead-acid) and leisure (lead-gel) batteries connected as a buffersystem, for continuous operation.If connected in buffer-system it can be paralleled with other energy powers (generator, batterycharger, solar panel, etc...).The battery charger doesn't work if it is not connected to a battery with a voltage of at least 3V.The system recharges the batteries in 3 cycles:1) Battery recharge at the max. Current, until it reaches the 28,8V value od end-charge.NB: this value is reached only if the battery is well-run.2) When the 28,8V value has been reached, the charging goes on for: 20 minutes for lead-acidbatteries, 6 hours and 20 minutes for gel batteries.3) Maintenance recharge at 27,6V continuous.In this way the maintenance current is assured for the full charge. In this cycle the recharging systemchokes the tyristor in order to invalidate the voltage peak.When the battery voltage is under than 27,2V, the system restarst from the 2nd cycle.Charging line IWUoUV I28,8V27,6VC26,6VV AIW Uo U UoV = Volt A = Ampere C = Carico - Loadt4