Toyota DAB Tuner - PZ473-J0210-00 - DAB Tuner - mode d'emploi

Troubleshooting
If you suspect something is wrong with your
DAB tuner, check and take steps as described
below.
If the described suggestions do not solve the
problem, it is recommended to take the unit to
your nearest retailer.
Problem
Noise/reduced sensitivity.
Unable to receive in auto
mode.
No signal.
Automatic fading in and out
of the volume.
Possible cause
A mobile phone is used
nearby.
No Service Station stored on
the Service List.
Antenna amplifier is not
installed correctly.
No Service is available.
DAB signal is too weak.
DAB signal is weak. This may
occur in tunnels, buildings,
under bridges etc., or if you
are too far away from an
emitting antenna.
Possible solution
If you are going to use a
mobile phone, move away
from the unit.
Activate Auto Tuning by briefly
pressing [AST], then update
the Service List by pressing the
[AST] Button more than
1.7 sec.
Check if the antenna amplifier
is correctly connected to the
antenna film.
Check if DAB is available in
your area.
Press [AST] button to activate
the automatic tuning.
Change to different Ensemble.
Wait until your vehicle reaches
a location with a stronger signal.
Change to different Ensemble.
Move the vehicle to an
unenclosed area.
Wait until the vehicle reaches
a location with a stronger
signal.
14 DAB Tuner
EN