OPAL/SMARAGD/RUBIN - Einhell-UNICORE sro
OPAL/SMARAGD/RUBIN - Einhell-UNICORE sro
OPAL/SMARAGD/RUBIN - Einhell-UNICORE sro
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Information on use / base / base diagram<br />
4<br />
Information on use of the greenhouse<br />
•All bolts, screws and nuts should be checked every three<br />
months and retightened if required.<br />
•After a storm or high winds please check all bolts, screws<br />
and nuts and ensure that the plastic web panels are<br />
correctly seated.<br />
•In the event of a storm or heavy winds please close the<br />
doors and windows of your greenhouse.<br />
•Suitable storm anchoring (not included) should be used to<br />
additionally secure the greenhouse in areas particularly<br />
prone to storms.<br />
•At temperatures below freezing (0 °C), never strike the<br />
plastic web panels with hard objects.<br />
•Snow should be cleared from the roof of the greenhouse on<br />
a regular basis to prevent dangerous snow loads from<br />
building up. A 10 cm layer of snow or a 2 cm layer of ice<br />
can already be dangerous.<br />
•The roof of your greenhouse is not designed to be walked on.<br />
•Never use any naked flames or similar in the greenhouse.<br />
Only use approved heating equipment.<br />
•Always make sure that you comply with the local building<br />
regulations in your area.<br />
Base diagram<br />
Concrete or brickwork base<br />
Base<br />
Please note: The greenhouse does not have a separate<br />
base profile. You can erect your greenhouse on a previously<br />
prepared brickwork or concrete base (see base diagram), or<br />
you can assemble it on a steel base (available as an<br />
optional accessory).<br />
!<br />
Important:<br />
If you do not want to erect your greenhouse on<br />
a masonry or concrete baseplate, ensure that<br />
your greenhouse is built on level, sturdy ground.<br />
Check levelness using a water level!<br />
Concrete / brickwork base<br />
It is very important for correct assembly of the greenhouse<br />
that the right angles in the base are all perfectly square.<br />
The base must be dead level, with perfectly square corners.<br />
Please use a spirit level to check. Please note: the base<br />
should be deep enough to be frostproof.<br />
Greenhouse La (cm) Li (cm) Ba (cm) Bi (cm) T (cm) H (cm)<br />
3 panels 224 204 259 239 10 Frost-proof depth (30)<br />
4 panels 295 275 259 239 10 Frost-proof depth (30)<br />
5 panels 366 346 259 239 10 Frost-proof depth (30)<br />
6 panels 437 417 259 239 10 Frost-proof depth (30)<br />
7 panels 508 488 259 239 10 Frost-proof depth (30)<br />
Ba<br />
La<br />
Bi<br />
ABA_OSR_Teil1_Titel+GB.pmd 4<br />
04.04.2006, 15:04<br />
Li<br />
T<br />
H<br />
h<br />
10 cm<br />
The base must be at least 10 cm<br />
wide (T) with a height (as<br />
required) of (h). The base must be<br />
dead level, with perfectly square<br />
corners.<br />
H