Funktionskontroll - ppm

6. Carry out the electrical installation as follows:
Installation
• Install the machine in accordance with installation category CAT II.
• Make a notch for electrical cables on the side of the machine.
• In the opening, fit the cable gland supplied and pull the cables through.
• Connect the machine to a separate isolator switch approved to local
standards. The isolator must be mounted on the wall close to the
machine.
• Connect to protective earth and to the supply voltage stated on the type
plate. Check that the connection has suitable overcurrent protection.
The correct fuse rating is stated on the type plate.
• All cables must be classified for at least 90 °C.
Variant Electrical connection Fuse Power
req.
L1 220-230 V, 1N+PE 50 Hz (TN) 1x16 A 3.0 kW
L2 230 V, 3+PE 50 Hz 3x16A 4.0 kW
L3 380-400 V, 3N+PE 50 Hz (TN) 3x10 A 4.0 kW
V2 220-230 V, 1N+PE 50 Hz (TN) 1x10 A 1.0 kW
L5 240 V, 2+PE 60 Hz (TN) 2x15 A 3.6 kW
V3 240 V, 2+PE 60 Hz (TN) 2x10 A 1.4 kW
L9 208 V, 2+PE 60 Hz (TN) 2x15 A 3.0 kW
L10 208 V, 3+PE 60 Hz (TN) 3x15 A 3.8 kW
V4 208 V, 2+PE 60 Hz (TN) 2x10 A 1.4 kW
L14 200 V, 2+PE 50 Hz (TN) 2x16 A 3.0 kW
L15 200 V, 3+PE 50 Hz (TN) 3x16A 4.0 kW
L18 200 V, 2+PE 60 Hz (TN) 2x16 A 3.4 kW
L19 200 V, 3+PE 60 Hz (TN) 3x16 A 4.4 kW
L22 220-230 V, 1N+PE 60 Hz (TN) 1x16 A 3.4 kW
L24 380-400V, 3N+PE 60 Hz (TN) 3x10 A 4.4 kW
7. Environmental requirements, sound level and weight:
Air humidity max 80 % at 31°C
Room temperature 5-40°C
Sound level 60 dB(A)
Weight Free-standing = 90 kg, under-bench = 105 kg
8. Steam
Connection 15 (1/2") mm
Pressure 30-300 kPa
Consumption 0,3kg/process
4 Edition 050625 5014907-00 Rev A