BEDIENUNGSANLEITUNG - Heym Waffenfabrik GmbH
BEDIENUNGSANLEITUNG - Heym Waffenfabrik GmbH
BEDIENUNGSANLEITUNG - Heym Waffenfabrik GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
16) Changing the barrel<br />
The barrel and receiver are one piece and are changed as a unit. The<br />
bolt assembly is universal and will fit any SR 30, except the magnum<br />
bolt will not fit a standard caliber SR 30, and standard caliber bolt will<br />
not fit a magnum caliber.<br />
Warning: Never attempt to interchange the bolt assemblies between<br />
magnum caliber and standard caliber under any circumstances.<br />
Caliber change is easily accomplished by the user in a few minutes<br />
using the following steps.<br />
• Remove bolt and magazine from rifle<br />
• Loosen the two internal wrenching captive screws in the trigger<br />
guard assembly.<br />
• Carefully remove barrel and receiver assembly from stock.<br />
Note: After screws are completely free of the receiver, place the rifle<br />
on a table, with the muzzle and the bottom of the recoil pad on the<br />
table top. With the palm of the hand push down on the top of the<br />
receiver where it joins the barrel until the forward recoil lug is free of<br />
the stock. This is a tight fit, and for this reason a second barrel assembly<br />
should be ordered with the rifle so the factory can ensure a perfect<br />
fit of both barrel assemblies.<br />
• Install desired caliber barrel assembly in stock.<br />
• Tighten internal wrenching screws, reinstall bolt and proper<br />
magazine.<br />
22