58-GIZLT-3, 58-GIZLT-3E - Tools.by

OBJ_BUCH-933-002.book Page 23 Tuesday, February 24, 2009 3:00 PM
Switching On and Off and Selecting Operating Modes
Do not point the laser beam at persons or animals and do not
look into the laser beam yourself, not even from a large distance.
Do not leave the switched on measuring tool unattended and
switch the measuring tool off after use. Other persons could be
blinded by the laser beam.
– To switch on the measuring tool, press the operating mode button 3.
– Press operating mode button 3 as often as required until the
requested operating mode is set.
Operating Mode
LED for laser beam
Horizontal 2 Vertical 4
1 Horizontal laser beam, green
pulsating
2 Vertical laser beam with 90° offset
vertical laser beam,
pulsating
green
3 Cross-line with 90° offset vertical
laser beam
4 Inclined cross-line with 90° offset
vertical laser beam (manual
operation without self-levelling)
green
Note: When the measuring tool is not in manual operation and not within
the self-levelling range, the laser beam flashes rapidly.
– To switch off the measuring tool, press the operating mode button
3 until the tool switches off.
Starting Operation of the Laser Receiver
(see figure B)
green
Protect the laser receiver against moisture.
Do not subject the laser receiver to extreme temperatures or
variations in temperature. As an example, do not leave it in vehicles
for longer periods. In case of large variations in temperature,
allow the laser receiver to adjust to the ambient temperature before
putting it into operation. In case of extreme temperatures or variations
in temperature, the accuracy of the laser receiver can be impaired.
red
red
1 609 929 T55 • 24.2.09
English | 23