ICC 1 S B / D - Kärcher

Warning!
Preparations
Stand sweeper on a flat surface
Remove the ignition key
When the refuse container is
always lower the safety
raised,
and secure with split
supports
pin.
Wear warning clothing when
—
repair work on public
performing
where it is dangerous
streets
at least 5 minutes after
Wait
engine before performing
stopping
Raise swept material container
Pull out safety split pins
Lower safety supports on left and
and secure with split pin
right
Pull-out the oil dip rod
Wipe off oil dip stick and slide it
Pull-out the oil dip rod
The oil level must be between the
—
Top up the engine oil if the oil
—
Do not fill up beyond "Max".
—
Danger!
the engine cool-down.
Let
Release the cap screw of the oilfilling
opening
Fill-in engine oil
Oil types: See technical data
—
Close the oil fill opening
Wait for at least 5 minutes
Provide a collecting container for
least 4 litres of oil
at
Allow the engine to cool off a little
Unscrew drain plug
Danger!
of burning if oil is hot
Risk
Use a new seal without fail when
the drain plug in again
screwing
Tighten drain plug to 25 Nm with
torque wrench
a
Unscrewing the side shrouding
Note:
an engine oil filter change
Perform
with the engine oil change.
together
Clean the supporting and sealing
surfaces
Operating instructions ICC 1 S B/D English
Maintenance tasks
Replace engine oil filter
Notes on safety
Apply parking brake
"Min" and the "Max" marks.
Check the engine oil level
level is below the "Min" mark.
because of moving traffic .
Change the engine oil
Top up engine oil
Check the engine oil level
Unscrew oil filter
Unscrew engine cover
the check.
in again
36