giroscopio modello 7000a manuale di installazione ... - Seakeeper

More documents

Recommendations

Info

WORK INSTRUCTIONS Page 4 of 4 Product: M7000A Document #: 018 Process: Installation Instructions, 8-Pin Shielded EMC Connector Rev.: 2 Serial Communications Cable Connections Note: Conductors “E” and “F” are reversed at Network Breakout Box Rear View of 8-Pin Shielded Connector Inside View of Network Breakout Box Terminals Note swapped wires above for terminals 5 & 6. Revision History Revision Description of Changes Date Approved 1 Initial release. 22 June 2009 B. Doutrich 2 Added note for swapped wires on page 4. 30 Sept 2009 S. Goss
WORK INSTRUCTIONS Product: M7000A Document #: 019 Process: Installation Instructions, 4-Pin Shielded EMC Connector Rev.: 2 Process Description: Component identification, cable preparation, and connector installation for 4-pin all-metal, shielded connector. Page 1 of 4 4-Pin Shielded Switched Output Connector for PCB Gyro Control J-Box, Turck 8141-0 Connector Shiel<strong>di</strong>ng Bell Seal Clamp Backshell Spacer Dome Nut Step 1 Component parts of the 4-pin all-metal shielded connector are identified in the picture above. Identify the components of the Turck CMBS connector and organize the necessary tools. Notes: The SHIELDING BELL can fit flush inside the BACKSHELL and may be inserted there for the duration of the connector installation. Recommended tools: Step 2 • Cable cutter • Electrician’s knife • Wire cutter • Wire stripper • Ferrule crimper • Miniature screwdriver Slide items on cable before beginning termination and connector assembly: clear heat-shrink tubing, dome nut, clamp, spacer, seal, & backshell. (Shiel<strong>di</strong>ng bell can be inside backshell.) Note: Clear heat-shrink tubing is only required if a label is to be applied to the cable.
Page 1 and 2: MANUALE DI INSTALLAZIONE Prodotto:
Page 31 and 32: WORK INSTRUCTIONS Product: M7000A D
Page 33: WORK INSTRUCTIONS Page 3 of 4 Produ
Page 37 and 38: WORK INSTRUCTIONS Page 3 of 4 Produ
Page 39 and 40: WORK INSTRUCTIONS Product: M7000A D
Page 41 and 42: WORK INSTRUCTIONS Page 3 of 3 Produ

giroscopio modello 7000a manuale di installazione ... - Seakeeper

Create successful ePaper yourself

Delete template?

Save as template?