Register and win! - Megaobrabiarki

Maintenance and care DangerAlways disconnect the mains plug and allow thesteam cleaner to cool down before performingany maintenance work.Rinsing the boilerRinse the steam cleaner boiler at the latest after10 boiler fillings. Fill the boiler with water and shake it strongly.This dissolves lime scaling residing on theboiler bottom. Empty water out.Descaling the boilerNote: If you always use usual commercial distilledwater it is not necessary to descale the boiler.As limescale builds up on the boiler walls, werecommend to descale the boiler in the followingintervals (RF=reservoir fillings):Degree of hardness ° dH mmol/l RFI soft 0- 7 0-1,3 55II medium 7-14 1,3-2,5 45III hard 14-21 2,5-3,8 35IV very hard >21 >3,8 25Note: Please contact your Conservancy Boardor the local water supply company to inquireabout the hardness of your water. Disconnect the mains plug from the socket. Allow device to cool down. Remove the safety cap from the device. Completely empty the steam boiler to removeexisting water (see fig. ). WarningOnly use products approved by KÄRCHER toexclude any damages of the appliance. User the KÄRCHER decalcifier sticks (orderno. 6.295-206) to decalcify the water. Pleasefollow the dosing instructions on the packagingwhile using the decalcifying solution.CautionUse caution when filling and emptying the steamcleaner. The descaling solution can have an aggressiveeffect on delicate surfaces. Pour the descaling solution into the boilerand allow it to react for approximately 8hours. WarningDo not screw the safety lock on the applianceduring the decalcifying.Do not use the steam cleaner as long as there isdecalcifying agent in the boiler. Completely empty the descaling solution after8 hours. A small amount of the solutionwill remain in the boiler. Therefore, youshould rinse the boiler two to three times withcold water to remove any residues of thedescaler. Completely empty the steam boiler to removeexisting water (see fig. ).Care of the AccessoriesNote: The floorcloth and the terry cloth coverhave been pre-washed and can be used immediatelyfor working with the steam cleaner. You can wash dirty floorcloths and terry clothcovers in the washing machine at 60°C. Donot use a liquid softener as this would affectthe ability of the cloths to pick up dirt. Youmay tumble dry the cloths.EN – 1119