Bruksanvisning för kaffebryggare - Jula

ENGLISH
OPERATION
Note: Clean the appliance before using for the first time.
Use
1. Fill the water container with water. Always add enough water for at least two cups.
2. Place the coffee filter in the filter holder. Add one measure of coffee for each cup.
3. Place the pot with the lid on the hot place. Plug in the power cord and press the power switch. The
indicator lamp comes on and the coffee maker starts working.
4. When the coffee is ready you should wait for a minute or so before removing the pot, as there may
be liquid left in the filter.
5. Leave the pot on the hot plate to keep the coffee hot.
NOTE: Use a paper filter of the correct size.
Drip-stop mechanism
It is possible to pour out coffee before brewing is complete. When the pot is removed from the hot plate,
the coffee stops dripping through the filter. You have to replace the pot on the hot plate within 20
seconds.
MAINTENANCE
Note:
• Unplug the power cord and allow the appliance to cool before cleaning.
• Do not immerse the appliance in water.
Clean loose parts with water and detergent, and wipe off the casing with a damp cloth. Do not use
abrasive detergent, steel wool or similar.
Descaling
Descale the appliance if it gives off large amounts of steam or if the brewing process takes a long time.
We recommend that you descale the appliance every other month according to the instructions below.
1. Place the empty pot on the hot plate.
2. Mix 3.5 dl of vinegar into 1 l of water and pour the solution into the water container.
3. Turn on the coffee maker for 1 minute. Turn off the coffee maker and allow it to stand for 30
minutes.
4. Turn on the coffee maker and allow the vinegar solution to run through. Empty the solution and
clean the pot.
5. Remove an residual vinegar solution by allowing two pots of clean water to pass through the coffee
maker.
Subject to printing errors and design changes over which we have no control.
www.jula.com
9