Pandrol Ind Inc Calorite Training Manual LP-AP CJ 2019 En-test (2)

T\ainee Worhbook Mod,ule 1
Step 2: Site Preparation
When you first get to the job site, certain things must be
done before you remove one single tool from the welding
truck.
¡ Check-out safety hazards:
- moisture, snow or frost in ballast
- slippery conditions
- multi-track
- obstacles
- traffic near level crossing
. Check-out fire hazards:
- dry grass, brush, wood chips
- flammable material
- combustible rail lubricators
. Find suitable location for disposal hole:
Caution!
Check for underground cables before digging!
. If necessary, update your job briefing so that:
- everyone knows about aII hazards
- each person is assigned responsibilities: (safety
watch, fire watch, first aid, etc.)
o Position fire fighting equipment nearby
o Wet down any dry/flammable material
Hot Tip! . Check for safety & fire hazards!
. Update your job briefing!
. Do not wet down the area immediately near the
weld or disposal hole!
. Make sure the area immediately near the weld or
disposal hole is free of anv form of moisture!
18