You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Trainee Worhbook
Mod,ule I
Step 4: Rail-end Preparation (cont'd,)
Q4: Why must all drilled holes be a minimum of 100
mm (4 in) away from the rail-end?
o
o
Q5: Why must rail-ends that have been torch-cut and have
cooled be cut back a minimum of 100 mm (a in) with
a rail saw?
o
o
Q6: When using a standard LP CJ OR AP CJ kit, why can
the maximum difference in rail height not exceed
3/16th in?
o
a
26