Pandrol Ind Inc Calorite Training Manual LP-AP CJ 2019 En-test (2)

Trainee Workbook
Module I
o Place mold halves together on rail, and gently rub back and
forth against the rail so they seat properly and make good
contact at the top. Make certain all sand dust is removed
from the rail.
o Put each mold half in its frame and place on rail so that
mold is centered over gap. Be sure that faces of both rails
can be seen from the top of the mold looking down
(Figure 20). Secure to rail by tightening mold clamp screws.
Mold should not extend below rail. Grind if necessary to
remove excess by using the mold base plate or a fiIe.
fi¡5- Eri$
figure 20
¡ Place the mold base plate on the plate holder. Roll paste
into 25mm (1") cylinder and apply all around base plate.
Flatten to same thickness as base plate (Figure 21). Place
under mold halves and secure with hangers. Compact paste
on long edges with packing rod (Figurc 22). Press paste at
both ends with fingers.
a
figure 21 ftgure 22
40