Brugsvejledning Bruksanvisning Bruksveiledning User's ... - Hwam

Start with the uppermost slab, two slabs in all for HWAM 7150 and three slabs for HWAM 7180. Pleasebe careful; the stone slabs are quite heavy.If the stove has rear outlet, lift off the convection grate (1) and both top plates (2 + 3). Lift off theslabs (4) on the front left-hand side of the stove by first lifting the slabs and then removing them. Startwith the uppermost slab, two slabs in all for HWAM 7150 and three slabs for HWAM 7180. Please becareful; the stone slabs are quite heavy.On a cold stove, the starting point of the feeler is controlled. The starting point on a cold stove is about30 0 above horizontal. It should feel easy going and bouncy when you push it, no matter if the stove iscold or hot. By rising or falling temperatures it must not move at a bound. The damper plates must bedry and clean and slide together unhindered. Control bars and slide gates may have to be smeared withWD40 (never oil).Door/glassA sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go about itin vertical movements (up and down). Follow up with a dry piece of kitchen roll. Check frequently toensure that seals in the door and ash pan are intact and not brittle. Failing this, they should be replaced.Use original seals only.SurfaceThe surface normally requires no treatment. Any damage to the coating may be remedied using a Senothermspray.GuaranteeThe guarantee does not cover damage due to insufficient maintenance!Operational problemsBlackened glass• The wood is too damp. Only use wood stored for at least 12 months under cover and with amoisture level not exceeding 20% RH.• Faulty seal in door. Fit new seal.Smoke in the room when opening door• The grate in the chimney may be closed. Open the grate.• Insufficient chimney draft. See section on chimney or contact chimney sweep.• Soot door leaking or dislodged. Replace or refit.• Never open the door when there are still flames on the wood.Uncontrollable combustion• Faulty seal in door or ash pan. Fit new seal.• If there is an excessive chimney draft, it may be necessary to set the regulator to its minimum position.Also do this all when the stove is not in use.• If the steel plates in the combustion chamber develop scales or become deformed, this is due toexcessive heat. Stop using the stove and contact the dealer.At interruptions that you cannot yourself rectify, you should contact the dealer.43