Tool Times - Apex Tool Group – Power Tools
Tool Times - Apex Tool Group – Power Tools
Tool Times - Apex Tool Group – Power Tools
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
proDUKTAnwenDUnGen proDUCT AppliCATion<br />
HoCHprozenTiGes siCHer VersCHiCKT HiGH-prooF AlCoHol sAFely sHippeD<br />
Herman Jansen Beverages Nederland B.V., ein Kunde unseres<br />
holländischen Distributoren Douwes International B.V. (www.douwes.nl),<br />
sendete uns diesen Monat das gezeigte Bild zum Thema<br />
Produktanwendung ein.<br />
Zwei Schrauber unserer bewährten Marke Cleco des Typs 88<br />
RSAL-5 CQ (400 RPM) sind hier im Einsatz, um die Verschlüsse von<br />
zwei und fünf Liter Kanistern mit dem korrekten Drehmoment von<br />
4,5 Nm fest zu drehen. Die niedrige Drehzahl ist dabei notwendig,<br />
um das Plastik nicht zu verletzen. Geschieht dies nämlich nicht<br />
sachgemäß, würde der kostbare Inhalt, in diesem Fall ein schottischer<br />
Whiskey, beim Transport auslaufen.<br />
Wir bedanken uns herzlich für diesen Beitrag. Auch im nächsten<br />
Monat können Sie uns wieder Ihre Produktanwendungen zusenden:<br />
tooltimes@apextoolgroup.com. Einsendeschluss ist der 20.04.2011.<br />
5<br />
Herman Jansen Beverages Nederland B.V., a client of our Dutch<br />
distributor Douwes International B.V. (www.douwes.nl), sent in the<br />
shown picture concerning our category product application for this<br />
month.<br />
Two fasteners of our established brand Cleco Type 88 RSAL-5<br />
CQ (400 RPM) are in use to close the seals of two and five liter<br />
canisters with the correct torque of 4.5 Nm. The low RPM is needed<br />
to avoid damage to the plastic. If this is not applied properly,<br />
the valuable content, in this case a Scottish Whiskey, would leak<br />
during transport.<br />
Thank you very much for this contribution. Also for the next month<br />
you can send in product applications: tooltimes@apextoolgroup.<br />
com. Deadline will be April 20th, 2011.