ATH Pneumatischer Montagefinger Bedienungsanleitung
ATH Pneumatischer Montagefinger Bedienungsanleitung
ATH Pneumatischer Montagefinger Bedienungsanleitung
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
Check that the mounting head is in the correct setting for the rim. If<br />
necessary, adjust it as described in the subsection "Adjusting the mounting<br />
head".<br />
Now place the tire diagonally on the rim so that the mounting head does not<br />
touch any tire parts during pivoting.<br />
Tilt the mounting tower by pressing the corresponding pedal.<br />
Position the tire so that the tire bead is still under the nose but still on the<br />
guide track of the mounting head.<br />
Note that the tire is located opposite the mounting head in the recess of the<br />
rim.<br />
Now start the rotation of the turntable.<br />
Pay attention to the correct bead course during the assembly process. Failure<br />
to observe this can result in serious tire damage.<br />
For tube tires, the tube must now be properly positioned in the tire. Make sure<br />
that this is so in the tire that it will not be damaged during further mounting.<br />
When mounting the second bead proceed as described for the first bead.<br />
It is also important to ensure that the tire is correctly positioned in the rim<br />
edge opposite the mounting head.<br />
If necessary, position the pneumatic mounting unit slightly downwards so that<br />
the bead cannot jump out. !!! WARNING a later pressing down ONLY through<br />
the finger can cause damage to the mounting head!!!<br />
© Copyright <strong>ATH</strong>-Heinl GmbH & Co. KG, 2013, All rights reserved / Printing errors and technical changings reserved / Version: 08/2013<br />
14
Change language