Leica Viva Series Technical Reference Manual - PRISM-Surveying ...

6.3.3 Mean Page
Description In order to check measurements, the same point can be measured more than once.
These measured points are assigned the class Meas. The various measured coordinate
triplets for one point can be recorded using the same point ID. If the averaging mode is activated,
an average is calculated when more than one measured coordinate triplet is available
for the same point ID.
The averaged point is given the class Avge. It is checked if the deviations of each single point
are within the limits configured in Job Properties:, Averaging page.
After averaging, the Mean page becomes available in Edit Point: and accessible from the
Survey application. Available functionality on the Mean page depends on the selected averaging
mode.
Averaging Defining the averaging mode and configuring the limits
The averaging mode and the limits are configured in Job Properties:, Averaging page. Refer
to "5.3 Job Properties and Editing a Job".
Description of averaging modes
Averaging Description
mode
Average When more than one measured coordinate triplet is recorded for the
same point, the average for the position and the height is computed.
Depending on the selected averaging method, the average will be
computed weighted or arithmetic (no weighting). The class Avge is
assigned to the averaged point.
Viva Series, Jobs & Data - Data 109