Ch15 Metal Extrusion And Drawing Processes

More documents

Recommendations

Info

<strong>Drawing</strong> Drawn rods used for: Shafts, spindles, small pistons Raw material for Rivets, Bolts, Screws, Nails Round and shaped cross sections ‘Rod’ is larger diameter than ‘wire’ ‘Wire’ is reduced at least once from ‘rod’ The cross section of a long rod or wire is reduced by pulling (or ‘drawing’) through a “draw “d “d “draw d d die” die” ” ”
FIGURE 15.19 Process variables in wire drawing. The die angle, angle the the reduction reduction in in crosssectional crosssectional area area per pass pass, the speed of drawing, the temperature, and the lubrication all affect the drawing force, F. F.
Page 1 and 2: Metal Extrusion and Drawing Process
Page 3 and 4: FIGURE 15.1 Schematic illustration
Page 5 and 6: Extruded Products Railings for sli
Page 7 and 8: Extrusion Process Direct (or Forwa
Page 9 and 10: FIGURE 15.4 Process variables in di
Page 11 and 12: FIGURE 15.5 Extrusion constant kk f
Page 13 and 14: FIGURE 15.6 Types of metal flow in
Page 15 and 16: Figure 15.1
Page 17 and 18: FIGURE 15.7 Typical extrusion extru
Page 19 and 20: FIGURE 15.8 Extrusion of a seamless
Page 21 and 22: FIGURE 15.10 Poor and good good exa
Page 23 and 24: Useful in hot extrusion: Lubricatio
Page 25 and 26: Cold Extrusion Extrusion Uses s sl
Page 27 and 28: Cold Extrusion E t sion Force = F
Page 29 and 30: FIGURE 15.13 Production steps for a
Page 31 and 32: FIGURE 15.15 Schematic illustration
Page 33 and 34: Hydrostatic Extrusion The pressure
Page 35 and 36: Extrusion Defects continued Pipe (a
Page 37 and 38: FIGURE 15.17 (a) Chevron cracking (
Page 39: FIGURE 15.18 General view of a 99-M
Page 43 and 44: Drawing Force Force Drawing force
Page 45 and 46: Drawing g Practice Usually, the sm
Page 47 and 48: Drawing g Practice continued Bundle
Page 49 and 50: Die Design g Die angles usually 6
Page 51 and 52: To improve die life Lubrication To
Page 53 and 54: Seams Drawing g Defects Longitudin
Page 55 and 56: FIGURE 15.23 Cold drawing drawing o
Page 57: Summary Extrusion: Push billet thr

Ch15 Metal Extrusion And Drawing Processes

Create successful ePaper yourself

Delete template?

Save as template?