2000 Approach Plus GPS Navigator Pilot Guide - Elite Simulation

2.3 Data Selector Knobs
Revision A
May 12, 1997
Chapter 2 Using the Navigator
The concentric selector knobs have two operating modes: page
selection and data entry.
2.3.1 Page Selection
Most Navigator modes have more than one page of data available.
Turn the small knob to go from page to page. Use both the large and
small selector knobs to change the top and bottom display lines.
• Use the knob to change the top line of the display.
• Use the knob to change the bottom line of the display.
2.3.2 Data Entry
Data selection is accomplished using the key and the selector
knobs.
• Use the knob to move the cursor within a field and to
move from field to field.
• Use the knob to change the data under the cursor.
• Press the key to complete the entry.
Some data fields, such as procedure names, have chevrons (< >)
around them. You may change the data in these fields by simply
rotating the knob. You do not need to press to open and
close the field; although that also works.
2-3