Workshop engine manual
Workshop engine manual
Workshop engine manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Engine<br />
Remove the seal plate and then the gearcase sealing<br />
cap.<br />
The by-pass screws must first be adjusted as follows:<br />
One and a half turns from the closed position<br />
Start the <strong>engine</strong> and warm it up. During this phase you<br />
should not accelerate because the high depression<br />
created in the induction lines could pipe the mercury<br />
from vacuometer.<br />
The <strong>engine</strong> rotation can be supported by using the<br />
starter.<br />
The attainment of the correct thermal speed is given by<br />
the intervention of the cooling fan.<br />
- 17 -<br />
B