Workshop engine manual

Engine
Fit the gasket with the inscriptions facing up and the
protrusion towards the march gear.
Insert the centering bushes between the head and the
cylinder.
Positioning the head.
Insert the washers on the encarcement if necessary
with the help of a screw driver to guide them onto the
internal encarcements.
Lubricate with antibinding grease of the HSC
MOLIKOTE type only on the nut threads.
Do not apply grease on the encarcement threads,
which must be well cleaned and degreased
Screw the bolts with a brugle key and press them at 35
N·m.
Tighten the bolts beginning with the internal ones
towards the external ones following the outline indicated
in the figure at 45 N·m.
Retrieve the distribution chain.
Insert the fixed sliding block with its screws and, after
having carefully degreased it, tighten it at a torque of 8
N·m. with MEDIUM THREAD BLOCKER.
- 29 -
45 N•m
35 N•m
8 N•m
B