Transceivermodule 1 TRX433-10A / TRX868-10A (Vers. 1.0E ...

Transceivermodule 10 TRX433-10A / TRX868-10A (Vers. 1.0E)
rf-mode: Setup for radio transmission:
1 = 19.2 kbit radio datarate, 100kHz channel grid (Maximum data speed)
2 = 4.8 kbit radio datarate, 25kHz channel grid (Standard setup)
3 = 1.2 kbit radio datarate, 12.5kHz channel grid (Maximum sensitivity)
handshake: Flow control: (for reliable communication flow control should always be activated)
1 = no flow control
2 = Hardware (RTS/CTS)
3 = Software (XON/XOFF)
The configuration mode can be terminated with the ESC-Key or it will terminate automatically after 1 Minute
of no data activity.
If you want a parameter not to change, hit the Enter-Key without any number input.
The configuration is saved into the EEPROM of the Transceivermodule and will remain there permanently.
Notice:
• The configuration must be done always with 19.2kbaud, even if you configured another baudrate
• The signal RTS/CFG (Pin 9) must be tied to a logic low level by a pulldown resistor during normal
operation, in order not to activate the configuration mode during powerup.
• Always input the numbers with three figures, including the leading zeros
• With the standard 868MHz Transceiver, only use rf-mode = 3, if the temperature range in use is
between 5°C and 40°C.