6724L3 1-a.book - SMC
6724L3 1-a.book - SMC
6724L3 1-a.book - SMC
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Mounting<br />
MOUNTING<br />
A TigerSwitch 10/100 unit can be mounted in a standard 19-inch<br />
equipment rack or on a desktop or shelf. Mounting instructions for each<br />
type of site follow.<br />
Installing Optional Modules: Before mounting the switch, be sure you<br />
install any optional modules. If you have purchased optional slide-in<br />
1000BASE-T, 100BASE-FX, or 1000BASE-X (GBIC) media expansion<br />
modules, install these modules now, following the instructions "Installing<br />
an Optional Module into the Switch" on page 3-4.<br />
Rack Mounting<br />
Before rack mounting the switch, pay particular attention to the following<br />
factors:<br />
◆ Temperature: Since the temperature within a rack assembly may be<br />
higher than the ambient room temperature, check that the<br />
rack-environment temperature is within the specified operating<br />
temperature range. (See page C-2.)<br />
◆ Mechanical Loading: Do not place any equipment on top of a<br />
rack-mounted unit<br />
◆ Circuit Overloading: Be sure that the supply circuit to the rack<br />
assembly is not overloaded.<br />
◆ Grounding: Rack-mounted equipment should be properly grounded.<br />
Particular attention should be given to supply connections other than<br />
direct connections to the mains.<br />
3-3