DISTRIBUTION PRODUCTS - Hubbell Power Systems

DC
4
OVERHEAD PRIMARY TAPS
HOT LINE TAP CLAMPS
HOT LINE TAPS FOR
MOUNTING CURRENT LIMITING FUSES
ALUMINUM
BRONZE
APPROX. DIMENSIONS APPROX.
RANGE
INCHES
WT.
EACH
CATALOG
LBS.
NUMBER
RUN TAP A B C (KG.)
GH201L** #4 Str. – 2/0 STr. Copper #6 Sol.-2/0 Str. Or C.L. Fuse Spade/Pin Terminal 4 1/4 4 1/8 1 3/4 .82 (.37)
ALUMINUM
GH201AL #4 Str. – 1/0 Str. Aluminum
4 1/2 4 1/8 2 1/8 .52 (.23)
#8 Sol. – 2/0 Str. Or C.L. Fuse Spade/Pin Terminal
GH202AL 795-4/0 AL 5 1/4 5 1/2 3 .80 (.36)
**RUS Listed
Product Data & Conductor Size
GH201 Series Hot Line Taps are specifically designed to
mount current limiting fuses directly on the line conductor
eliminating the need for increased pole height
to maintain adequate clearances.
• Fuse replacement can be readily accomplished using
standard hot stick techniques.
• Accommodates either spade or pin terminals of current
limiting fuses as well as conventional solid or
stranded tap conductors.
• Tap position is located to provide adequate room for
installation tools as well as vertical fuse alignment.
Permanent contact pressure is maintained by the use
of a heavy duty stainless steel Belleville spring. Long
“duck-bill” provides a guide for easy initial contact
with run conductor.
• Forged eyebolts provide consistent strength and uniform
expansion under loading conditions.
Material: Body and Keeper 201 – Bronze
Body and Keeper 201A – Aluminum Alloy
Eyebolt – Bronze – Tin Plated
Eyestem – Bronze Alloy, Forged
Spring (on eyestem)–Stainless Steel Belleville
Note: Add “L” suffix for factory loaded inhibitor in
main conductor groove, ex. GH201AL
Add “LBE” suffix for factory loaded inhibitor in
main conductor and tap eyebolt, ex GH201ALBE
DECEMBER 2012 ANDERSON HUBBELL ® POWER SYSTEMS FARGO ®