Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Mounting and operating instructions <strong>AMTRON</strong> R○ X-<strong>50</strong><br />
System loop<br />
The following values can be displayed in the system loop:<br />
SYStEM<br />
Editing methods<br />
FNr 12345678<br />
SYS H-<strong>50</strong><br />
DAT 18.12.05<br />
FW 1.05.00<br />
HW 2.01.10.00<br />
Fabrication No. of the instrument<br />
Version of the device<br />
Date of manufacture<br />
Firmware version<br />
Hardware version<br />
The following examples show the editing methods in Service mode [S-Edit].<br />
For non calibrated totalisers it is possible to adjust values, digits and sign (+/-) in Program mode [P-Edit] too.<br />
Number entry<br />
If it is possible to adjust a (multi-) digit in an operating loop, then follow the procedure in the graphic bellow:<br />
S-Edit<br />
ImP 1.000 kWh<br />
ImP 0001.000 1<br />
ImP 0001.000 2<br />
ImP 0001.000 7<br />
Activate Service Mode with Service key<br />
Press Enter key to enter in Edit mode<br />
Adjust the digit (1) with the Select key<br />
Change to next digit (2) with the Enter key<br />
Adjust the digit with the Select key<br />
:<br />
:<br />
Change to last digit (7) with the Enter key<br />
Adjust the digit with the Select key<br />
Finish the entry with the Enter key<br />
The values and digits can be adjusted in their possible range from 1 to 8 digits between 0 and 9. Partly the sign (+/-)<br />
can be set.<br />
VD 3-248 e 03.2006 20 Aquametro AG