CS1D-CPU

New ApplicationInstructions
x
Function CS1D-CPU@@H CS1D-CPU@@S
Duplex CPU, Single I/O Expansion Duplex CPU, CS1D CPU Units
System
Dual I/O Expan- for Single CPU
sion System Systems
Pre-Ver.
1.1
Ver. 1.1 Ver. 1.2 Ver. 1.3 Ver. 1.3 Ver. 2.0
MILH, MILR, MILC --- --- --- --- --- OK
=DT, DT, =DT
--- --- --- --- --- OK
BCMP2 --- --- --- --- --- OK
GRY --- --- --- --- --- OK
TPO --- --- --- --- --- OK
DSW, TKY, HKY, MTR, 7SEG --- --- --- --- --- OK
EXPLT, EGATR, ESATR,
ECHRD, ECHWR
--- --- --- --- --- OK
Reading/Writing CPU Bus
Units with IORD/IOWR
Instructions
--- --- --- --- --- OK
Note 1. OK: Supported, ---: Not supported
2. The Removal/Addition of Units without a Programming Device function is
supported only by CS1D CPU Units with unit version 1.3 or later and a Duplex
CPU, Dual I/O Expansion System.
If the Removal/Addition of Units without a Programming Device function is
selected in a Duplex CPU, Single I/O Expansion System, the function will
operate as the earlier Unit Removal without a Programming Device function.
3. In a Duplex CPU, Single I/O Expansion System, only Basic I/O Units and
Special I/O Units can be added with the Online Addition of Units and Backplanes
function. The system may stop operating if an Expansion Backplane
is added online.
Unit Versions and Programming Devices
CX-Programmer version 7.0 or higher is required to use the functions added
to the CS1D-CPU@@H CPU Units in unit version 1.3 (Duplex CPU Systems).
CX-Programmer version 4.0 or higher is required to use the functions added
to the CS1D-CPU@@S CPU Units in unit version 2.0 (Single CPU Systems).
The following tables show the relationship between unit versions and CX-Programmer
versions.